Product details of Faspeed SSD 2.5 Inch SATA 3 (SATA III) Internal Solid State Drive for NAS Desktop PC Laptop
Capacity:120G
With reasonable cost, customer can significantly improve speed for PC made out of traditional hard disk.
Product Detail specification :
1. Capacity: 120GB
2. Sequential Data Read/Write speed: 10X faster than 7200RPM hard drive.
3. Data retention: 10 years
4. MTBF:1,000,000 Hours
5. WARRANTY : 3 YEARS
6. Outline: standard 2.5 inch SSD.
7. Interface: SATA III, compatible with SATA 1.5/ 3.0/ 6.0Gb/s
8. Operating temperature range form 0℃ to +70℃
9. SMART power management.
Inside the package:
one SSD,
one manual,
one blister,
one box.
1. Product details of Faspeed SSD 2.5
Inch SATA 3 (SATA III) Internal Solid
State Drive for NAS Desktop PC Laptop
Capacity:120G
With reasonable cost, customer can significantly improve
speed for PC made out of traditional hard disk.
Product Detail specification :
1. Capacity: 120GB
2. Sequential Data Read/Write speed: 10X faster than
7200RPM hard drive.
3. Data retention: 10 years
4. MTBF:1,000,000 Hours
5. WARRANTY : 3 YEARS
6. Outline: standard 2.5 inch SSD.
7. Interface: SATA III, compatible with SATA 1.5/ 3.0/ 6.0Gb/s
8. Operating temperature range form 0℃ to +70℃
9. SMART power management.
Inside the package:
one SSD,
one manual,
one blister,
2. one box.
Attention:
No SATA cable or adapter inside.
Please check if there is mechanical damage on the package
before install SSD.
If you see a failure, please record and report failure mode for
troubleshooting.
About read/write speed, the reference speed value on this
product page is based on our evaluation on our test PC. It
may vary from different hardware in customer side. The
evaluation was done on SATAIII interface, speed will be lower
if it's SATAII connection.
About SSD detection, our SSD compatibility has been
evaluated in design and development phase, we choose most
commonly used controller to maximize compatibility. In real
world, there could be very few compatibility issue, if
unfortunately you met such issue please first check hardware
connection is correct, if problem stays please contact us for
resolution.
3. About system installation, there are a few case customer
failed to install SSD in first try, in such scenario please double
confirm the boot disk is functioning properly. A colone
software (e.g. AOMEI Partition Assistant) could help you
simplify the process.
About temperature, this product doesn't support real time
temperature measurement. The temperature value you see
from evaluation tool (e.g. SMI SSDToolbox) is a default value
set in S.M.A.R.T, it doesn't mean the actual temperature.