1. JACKSHAFT TO
INBOARD
CONVERSION OF
THE BIX

2. ONE FINAL LOOK, THE LAST TIME AS A JACKSHAFT

4. SAWING WITH A DIAMOND ABRASIVE BLADE

5. GETTING INTO THE CORNERS WITH A SABRE SAW

6. COCKPIT LINER

7. LAY-OUT THROUGH STARBOARD DRIVE CUT-
OUT

8. LAY-OUT THROUGH PORT DRIVE CUT-OUT

9. LAY OUT UNDER PORT FISH BOX

11. STRINGER IS REMOVED TO ALLOW CROSS CUT

13. CUT ACROSS THE KEEL

14. AS SEEN FROM UNDER STBD SIDE

15. CUT OUT AS SEEN FROM BOTTOM

16. REMOVED SECTION

18. TAPERING THE LAMINATES IN PREPARATION FOR NEW INSERT

19. INBOARD INSERT WITH LAY-OUT TO FIT CUT-OUT

20. INBOARD INSERT WITH PARTIAL STRINGERS

22. INBOARD INSERT READY TO BE CUT

23. INBOARD INSERT AFTER TRIMING AND TAPERING

24. INSERT GOING INTO PLACE

25. FITTED AND READY FOR PERMANENT INSTALLATION

26. OFFICIALLY AND INBOARD

28. STRUCTUAL GLASSING AND FILLING THE TAPER

36. BEFORE
AND
AFTER