3. Run Program in DebugRun Program in Debug
We will continue with the program mentioned in previous session. Run
the program in Debug mode.
4. Debug Mode ContinuesDebug Mode Continues
-Mule application will be running in “Mule Debug” perspective
-Mule Debugger perspective will open and application would start running
in debug mode. Upon successful deployment, debugger view will open
5. Some Debugging IssuesSome Debugging Issues
-There could be some scenarios where application might not run in
debug mode. Anypoint doesn’t show the error sometimes in that
case.
-Possible Solution
-Change the port number for debug mode
-Restart the workspace
-Port number can be changed by going into below
-Right click -> Debug-> Debug Configurations -> Mule
Debugger-> Port
8. Debug Program (Continues)Debug Program (Continues)
Application will be paused on break points and debugger view will open
with all the properties associated with the message at that time
9. Debug Program (Continues)Debug Program (Continues)
You can play/evaluate with mule expression evaluator in order to check
the expression syntax you are writing
10. Debug Program (Continues)Debug Program (Continues)
You can play/evaluate with mule expression evaluator in order to check
the expression syntax you are writing
11. Debug Program (Continues..)Debug Program (Continues..)
Program can be continued.. By pressing f8 or next message processor
button under mule debugger
Debugger is having capabilities to check the properties at runtime,
evaluate the expression, analyze each component/processor in detail