1. Page 1 of 2
Model CC1 Charging Cabinet
Installation Guide
Cabinet for charging the iPad and Tablets
Model CC1 has 30 numbered slots for the
iPads or tablets
Electrical outlets are UL approved . There is a
total of 32 outlets, They are arranged in 2 vertical rows of 16 outlets on a power strip. Each
strip has a separate power cord. The power
adapters for the iPads or tablets are plugged
into the power strip outlets.
GETTING STARTED
Please plan for a 32” X 24 X 12” location that is no more than 6 ft. from a dual (2) electrical outlet.
A wall or surface must be capable of holding 60 pounds which is the combined weight of the cabinet when filled with tablets. For a wall use heavy wall anchors with washers such as a Tapcon ™
anchors with a washer, and attach it at all 4 cabinet back anchor points. Use the appropriate wall
attachment procedure for the building wall type to insure the cabinet will not come loose.
Shown; Tapcon anchor
with washer in T slot on
back of cabinet
16”
Wall Mounting hardware ( not supplied ) should be
used at all 4 mounting holes located on the rear
panel. These are indicated by the arrows.
Countertop Mounting hardware should be used for the
4 mounting holes in the base of the cabinet.
NOTE: This cabinet must be
mounted or secured due to
the weight and propensity to
tip when the doors are open.
CC1 iPad Cabinet Installation Guide ver 00
2. Page 2 of 2
Model CC1 Charging Cabinet
IPAD or TABLET low voltage power cords ( thin white cords) are run under the shelf and attached at the
shelf front using the special J holes. Coil extra length of low voltage power cord in the cut out voids under the shelf. Insure that enough cord hangs free to fit the device in the slot.
Angle View
Front view
J Holes
Cabinet Sections , Front view
1
2
Section 1
3
iPad is a trademark of the Apple Corp. USA
Hookup cables to iPads or tablets
A wiring strategy should be used when running the
charging cables. This 4 Sections plan shows one
method to hook up the cables. Use the outlets on
the top half of the left power strip (Section 1) and
run them to the top shelf slots 1-7. Take the bottom half of the left power strip (Section 3) and run
them to the bottom shelf slots 16-24. Use the
same procedure for the other side power strip.
4
DUKANE CORP AV SERVICE DEPT
2900 Dukane Drive
St Charles, IL 60174
800-676-2487
Fax 630-584-5156
avservice@dukane.com
http://www.dukane.com/av/service/