1. Machines Hand-Over to Production at JHI
Machines are selected as per requirements of components and expected schedules.
Process followed to decide on these machines
Enquiry -> Technical discussion with supplier-> receipt of final proposal -> Comparison of
proposals -> finalization of scope with supplier -> Techno-commercial negotiations -> Purchase
order-> Inspection -> Trials -> Commissioning at works -> components trials -> confirmation of
accuracies required -> Hand-over to Production.
1. Vertical Machining Centers from BFW , Mazak
2. Horizontal Machining Centers from BFW , Mazak
3. Washing Machine for
2 & 3Cylninder Head for Mahindra
Eagle , 2Cylinder ,W201 Oil Sump for Mahindra
2Cylinder ,W201 Cam Cover for Mahindra
3lit Oil Sump for Tata Motors
4. Leak Test Machine for
2 & 3Cylninder Head for Mahindra
Eagle , 2Cylinder ,W201 Oil Sump for Mahindra
2Cylinder ,W201 Cam Cover for Mahindra
3lit Oil Sump for Tata Motors
5. Washing Machine for 4cylinder Head for Ford
6. Leak Test Machine for 4cylinder Head for Ford
Special Fixtures and Equipments Hand-over :-
1. Assembly fixtures with low cost automation and Poka-Yoke for
Eagle , 2Cylinder ,W201 Oil Sump for Mahindra.
2. Cam Carrier Lower & Upper Assembly fixture with Electronic Torque Gun.
3. Bush Pressing Fixtures for Transmission Housing and Feed Bracket with Load cell
4. Probing implementation in 4cylinder Head machining on HMC for Ford
5. Probing implementation in 3cylinder Block machining on VMC for Mahindra
6. Development of Hydraulic fixtures with design concept ,hydraulic items requirement for
@24 components and @ 50 fixtures