Cremation processor

1. Operating the BL-499
Processing Center

2. The processor is integral to our
crematory operation

5. The BL-499 replaces the $14K Mathews’
ECP-200 “free” processor.

6. The operator should wear protective
gear: gloves, dust mask & ear protection

7. We have installed a light over the
processor – reach up for switch on top

8. Tools

9. Power-on with wall switch – off when leaving
for the day. (No off/on switch on machine)

10. Push the Start button to activate
machine, then again to start the fan

11. One push for starting panel

12. 2nd Start-push activates System,
and will shut down fan after 10 minutes

13. The lights across the top let you know when to
Load, when Processing, & when Complete.

14. Cooling tray for quicker cooling when
cremains are very hot

15. After sweep-out, remove the cremains
transfer pan from cremator

16. Pour hot cremains into the cooling tray
Be sure the fan has been activated

17. Cremains can be inspected and metal
& large objects removed

18. Pour cooling tray into processor tray for final cooling and
use magnetic tool for ferrous metal removal

19. Place envelope & tag on machine front
Run the magnet over the cremains

20. With hopper door open, sweep/push
cremains into chute, do not pack

21. If the hopper chute fills, close lid and
run processor for a few seconds then
continue the sweeping in of cremains

22. Sweep cremains off hopper door ledge

23. Sweep the fan cover

24. When hopper door is closed the processor
starts; if it does not start, open and slam

25. When hopper is closed “Processing” lights up
When finished “Processing Complete” lights up

26. Open hopper door, tap with rubber mallet

27. Remove 3 magnetic holders, remove
bag of processed cremains, place in tray

28. Place metal strainer into top of bag

29. Open hopper, sweep out any metal &
cremains into the pan

30. Remove pan – Catches all metal

31. Pour pan into metal strainer

32. It is a treasure hunt - valuable

33. Amazed at what this machine finds

34. Dump all metal into marked bucket

35. After removing filled bag, always replace
bag – leave fan on to help position bag

36. Use the magnets to hold the bag

37. If the filter light comes on, check the
limit switch – reposition or change filter

38. Fill urns in front of processor fan

39. If you have any questions call:
Guy Esposito: 407-341-9909
Implant Recycling