꧁༒☬ 7042364481 (Call Girl) In Dwarka Delhi Escort Service In Delhi Ncr☬༒꧂
Rear Center Console Insert Installation Guide
1. EVannex® — Aftermarket Accessories for the Model S
3413 SW 14
th
Street •• Deerfield Beach, FL 33442 •• www.evannex.com
RCCI - Installation Instructions
Thanks for purchasing the RCCI.
The RCCI is designed to fit at the center of the rear bench seat of the Tesla Model S. In
addition to these Installation Instructions, we’ve created an Installation Video that can be
viewed at www.evannex.com.
Quick Start Installation Steps:
Step 1. Build a simple “quick install tool” using a wire clothes hanger (Photo # 1). CAUTION:
Be sure that both ends of the tool are rounded to preclude any damage to the upholstery.
Step 2. Place the RCCI near the rear centerline of the
rear bench seat. For standard seats, the centerline is
defined by a vertical seam in the upholstery. Allow 6 –
10” of space between the rear of the RCCI and the seat
back during Steps 3, 4 and 5.
Step 3. From the trunk, push the “quick install tool”
through the seam at the bottom center of the seat
back. It only needs to protrude inside the passenger
compartment by 4 or 5 inches. CAUTION: If the “quick
install tool” doesn’t slide easily into the back seat, DO
NOT force it. Go to the rear seat, reach into the seam
and pull it through to avoid any possible damage to
your upholstery. See Photo # 2.
2. EVannex® — Aftermarket Accessories for the Model S
3413 SW 14
th
Street •• Deerfield Beach, FL 33442 •• www.evannex.com
Step 4. From the rear seat,
attach the snap hook to the
loop in the “quick install
tool.” See Photo # 3.
Step 5. From the trunk, pull
the “quick install tool”
through so that the snap
hook and strap are clearly
visible. CAUTION: If the
“quick install tool” doesn’t
slide easily under the seam of
the seat, DO NOT force it. Go
to the rear seat, reach into
the seam and push it through
to avoid any possible damage
to your upholstery. Once the
tooi is visible in the trunk,
unsnap the hook from the tool and pull the strap all the way into the trunk. Place the “quick
install tool” in the trunk foot well so that you can use it again as required.
Step 6. Attach the snap hook to the horizontal
anchoring bar in the upper center of the seat back
(Look for a slit in the seat backing). Tighten the strap.
(Photo # 4.)
Step 7. From the rear seat, adjust the front strap so
that the curved hook fits under the lower edge of
the rear seat cushion with slight tension. (Photo #
5).
Congratulations! The RCCI is now a part of your
Model S.
REMOVAL: To remove the RCCI, undo the front strap
by removing it from the seat edge. From the trunk,
unsnap the hook fastening the RCCI to the horizontal
anchoring bar. From the rear seat, pull the rear strap
and snap hook under and through. The RCCI may be
stored on the floor or in the frunk until it is time to
re-install it.