ELECTRICAL ENGINEERING PROJECT TOPICS AND MATERIALS.docx
1. ELECTRICAL ENGINEERING PROJECT TOPICS AND MATERIALS
ATTENTION:
BEFORE YOU READ THE PROJECT TOPICS BELOW, PLEASE READ THE INFORMATION
BELOW.THANK YOU!
NOTE:
WE WILL SEND YOU THE ABSTRACT, TABLE OF CONTENT AND CHAPTER ONE OF YOUR
APPROVED TOPIC FOR FREE.
CHOOSE FROM THE LIST OF TOPICS BELOW. SEND YOUR EMAIL ADDRESS AND THE
APPROVED PROJECT TOPIC TO ANY OF THESE NUMBERS-08068231953, 08168759420
WE WILL THEN SEND THE ABSTRACT, TABLE OF CONTENT AND CHAPTER ONE FOR
FREE
NOTE ALSO:
WE CAN ALSO DEVELOP THE FULL PROJECT WORK
CALL: 08068231953, 08168759420
ELECTRICAL ENGINEERING PROJECT TOPICS AND MATERIALS
1. Design and implementation of an android based
automatic sector antenna positioning using
atmega328p. (case study: namuyenje site in
mokono)
2. 2. Comparative analysis of practical skills acquisition
in electrical/electronic engineering training program
in KENPOLY in NIGERIA
3. Mixed h_2/h_∞ and robust predictive to control
wheeled mobile robots with time delay
4. Buildings maintenance cost
5. Impact of electronic payment system in the nigerian
financial institution (a case study of first bank
nigeria plc)
6. Design and construction of 2kva inverter
7. Design of an electronic siren circuit
8. Design, development and testing of a liquefied
petroleum gas powered tomato dryer with water
energy stotage
9. Nitrogen doping effect on tin-selenium thin films for
phase change memory applications
10. Contingency and security analysis for power
system network . Case study _ nec grid
3. 11. Automation of waste segregation via sensors by
using plc
12. An assessment of embedded power generation
in nigeria
13. Greenhouse wireless monitoring and control
system based on sensor network
14. A comparison between proportional-integral-
derivative and fuzzy controllers for water tank
15. Reliability centered maintenance (rcm) for asset
management in electric power distribution system'
16. Reliability centered maintenance (rcm) for asset
management in electric power distribution system
17. Design and construction of an automated street
lighting system
18. Reliability evaluation of secondary distribution
system in nigeria: a case study of ayetoro 1
substation, aguda, lagos state
4. 19. Overcoming barriers to new learning
technologies in a university setting: the case of
covenant university
20. Application of common management
information protocol (cmip) in atm network
bandwidth allocation system
21. A co-ordination study of protection system for
mala oil fields in block 5a
22. An intelligent load shedding system application
in sudan national grid
23. Evaluation and improvement of power quality
on distribution network: a case study of covenant
university, ota
24. A new voltage stability index for predicting
voltage collapse in electrical power system networks
25. Optimizing of dc motor speed using pid
controller and grey prediction algorithm
5. 26. Design and implementation of printed circuit
board computer numerical control machine with
path planning algorithm
27. Assessment and upgrading of scada system for
petroleum pipelines
28. Maximum power point tracker of wind energy
generation systems
29. Performance evaluation of ant colony
optimization for routing in wireless sensor networks
30. The optimization of generating plants in a
microgrid: the covenant university electric power
network experience
31. Reliability evaluation of secondary distribution
system in nigeria: a case study of ayetoro 1
substation, aguda, lagos state
32. The electrical engineer and the community a
clarion call for sensitivity and long term investment
33. Derivation of the bandwidth resource allocation
in an atm-based network
6. 34. Short term electrical load forecasting using
fuzzy logic
35. Battery charging control for wind energy
generation system
36. Load frequency control in multi machine
systems using pid controller
37. Performance assessment of thyristor controlled
series compensator (tcsc) in sudanese national grid
38. Performance compration of equalization
techniques in downlink long term evolution
39. Development of plc program and monitoring
system for robotic arm
40. Globalization, energy, education and poverty
alleviation: prospects & challenges for developing
nations
41. Reliability centered maintenance (rcm) for asset
management in electric power distribution system
42. Dual axis sun tracking system using a
microcontroller and a stepper motor
7. 43. Development of nonlinear control schemes for
electric power system stabilization
44. Nero-fuzzy controller design for permanent
magnet dc motor
45. Positioning the electric power sector for
electricity sufficiency in nigeria to meet up with
vision 2020.
46. An intrusion detection system using artificial
neural network based on intrusion behavior
47. Positioning the electric power sector for
electricity sufficiency in nigeria to meet up with
vision 2020..
48. Positioning the electric power sector for
electricity sufficiency in nigeria to meet up with
vision 2020.
49. Boiler control design using fuzzy logic
50. Wireless electrical power transfer for charging
low power appliances
8. 51. Nigeria electricity industry: issues, challenges
and solutions
52. A fault detection and protection scheme for a
200 mva transformer using fuzzy logic
53. Contingency analysis in presence of svc
controller of sudan national grid for electricity
54. Cadmium chloride thin films: hydration-
dehydration
55. Gsm based communication-sensor (commsense)
system
56. The relevance of load following capability of
nuclear power plant for the south african grid
57. An electrical power system for cubesats
58. Active object recognition for 2d and 3d
applications
59. Investigation into the use of the microsoft kinect
and the hough transform for mobile robotics
60. A 3-phase z-source inverter driven by a novel
hybrid switching algorithm
9. 61. Ultrasonic spectroscopy of liquid filled
piezoelectric tube
62. Multivariable control of a nonlinear process
output prioritisation by error redistribution
63. Fractal image compression and the self-affinity
assumption: a stochastic signal modelling
perspective
64. Novel low cost synchronisation network for
spread spectrulyi systelvis
65. Damping of electromechanical oscillations using
power system stabilizers
66. 3-phase gate-turn off thyristor inverter
67. Electron beam decomposition of cdci2
68. A current source inverter-fed constant air gap
flux controlled squirrel cage induction motor drive.
69. Natural variable modeling and performance of
interior permanent magnet motor with concentrated
and distributed windings
10. 70. A fault detection and protection scheme for a
200 mva transformer using fuzzy logic
71. A modified linear contribution factor model for
improvement of reliability indices of electrical
distribution systems
72. Sliding mode direct torque control of three
phase induction machine applicable in electric
vehicles
73. Effects of selected roofing materials on air
navigation signal propagation
74. Development of countermeasures against some
internet security threats
75. Identifying permeability controls by use of
gravity method in menengai geothermal field, kenya
76. Load optimization by steam and blade washing
in a flash type power plant-a case study of olkaria ii
geothermal power plant
11. 77. Improved energy efficiency using facts-device
technique: a case study of ogui-enugu power
distribution network.
78. High power loss reduction in enugu electrical
distribution systems using heuristic technique for
capacitor placement.
79. Performance characteristics of a transfer field
machine operating in the asynchronous mode
80. Automated energy meter reading by using radio
frequency technology
81. Modeling h2s dispersion from proposed
menengai geothermal powerplant
82. A case study of three dimensional inversions of
electrical resistivity to image geothermal system in
korosi geothermal prospect-kenya
83. Evaluation of potentials for renewable energy in
the power system in sudan
84. Dynamic loss of load performance of an
autonomous self-excited induction generator (seig)
12. 85. Performance evaluation of channel estimation
and detection algorithms for 5g massive mimo
system
86. Some methodologies for facts controllers
87. Construction and test of a delta modulated
buck type 3 phase converter
88. Design of digital filters using incremental
changes in processing
89. Design of adaptive control schemes for an
industrial robot arm
90. Correlation of load-point reliability indices with
power system fault levels
91. Dynamic modelling and implementation of split-
phase induction machine
92. Synthesis of a hysteresis motor
93. The role of technicians and craftsmen in a
developing country
13. 94. Investigation and simulation of a micro hydro,
solar and biomas hybrid energy system for off-grid
locations in nigeria
95. Efficient spectrum-handoff schemes for
cognitive radio networks
96. Post graduate professional experience in
electronic and electrical engineering
97. Evaluating the performance of the unified power
flow controller (upfc) on fault current limitation in
the nigerian 330kv power network
98. Sliding mode direct torque control of three
phase induction machine applicable in electric
vehicles
99. Modeling modelingand parameter extraction of a
and parameter extraction of a 214 mva turbo- 214
mva turbo-generator driven by dc generator driven
by dc motors during off- motors during off-li
100. A hybrid modulation scheme for cascaded h-
bridge inverter cells
14. 101. Dynamic analysis of induction machine
connected to infinite bus-bar
102. A generalized solution to the thin-wire elliptical-
cylindrical helical-beam antenna problem.work
103. Short circuit modelling and parameter
extraction of a turbo generator
104. Short circuit modelling and parameter
extraction of a turbo generator
105. E beam induced decomposition of inorganic
solids
106. Electric vehicle charging infrastructure with
three-way automatic switch
107. Privacy-by-design for internet of things(iot):
implementing user autonomous options in a smart
home scenario
108. A low cost anti-theft tracking system for electric
vehicles
109. Automatic three phase changer
110. Store management system to jit
15. 111. Optimal location and sizing of distributed
generation in distribution network using adaptive
neuro-fuzzy logic technique
112. Impact of weather variables on electricity power
demand forecast using fuzzy logic technique
113. Assessing the benefits and challenges of
distributed generation in nigeria power distribution
network
114. Speed control of marine diesel engine self-
tuning based on fuzzy pid control and genetic
algorithm pid
115. Square wave to sinounsidal wave form
116. Microstructurally engineered p-layers for
obtaining high open-circuit voltages in a-si:h n-i-p
solar cells
117. Maximization of the open circuit voltage for a-
si:h n-i-p solar cells by incorporation of
protocrystalline si:h p-type layers
16. 118. Correlation of light-induced changes in a-si:h
films with characteristics of corresponding solar
cells
119. Photovoltaics — a path to sustainable futures
120. Absence of carrier recombination associated
with the defect pool model in a-si:h i-layers: evidence
from current-voltage characteristics on p-i-n and n-
i-p solar cells
121. Light induced defect states in hydrogenated
amorphous silicon centered around 1.05 and 1.2ev
from the conduction band edge
122. Numerical simulation of the direct application of
compound parabolic concentrators to a single effect
basin solar still
123. 3d-mapping optimization of embodied energy of
transportation
124. Reducing greenhouse gas emissions by inducing
energy conservation and distributed generation from
elimination of electric utility customer charges
17. 125. Increasing pv velocity by reinvesting the nuclear
energy insurance subsidy into large scale solar
photovoltaic production
126. Expanded microchannel heat exchanger:
design, fabrication and preliminary experimental
test
127. Optimizing limited solar roof access by exergy
analysis of solar thermal, photovoltaic, and hybrid
photovoltaic thermal systems
128. Effects of spectral albedo on solar photovoltaic
devices
129. Simulations of greenhouse gas emission
reductions from low-cost hybrid solar photovoltaic
and cogeneration systems for new communities
130. Mobile open-source solar-powered 3-d printers
for distributed manufacturing in off-grid
communities
18. 131. Performance of u.s. hybrid distributed energy
systems: solar photovoltaic, battery and combined
heat and power
132. Double amorphous silicon-carbide p-layer
structures producing highly stabilized pin-type
protocrystalline silicon multilayer solar cells
133. Light-induced defect states in hydrogenated
amorphous silicon centered around 1.0 and 1.2 ev
from the conduction band edge
134. Photovoltaic system performance enhancement
with non-tracking planar concentrators:
experimental results and bi-directional reflectance
function (bdrf) based modelling
135. Impact of snow and ground interference on
photovoltaic electric system performance
136. Levelized cost of electricity for solar
photovoltaic, battery and cogen hybrid systems
137. Emerging economic viability of grid defection in
a northern climate using solar hybrid systems
19. 138. Aquavoltaics: synergies for dual use of water
area for solar photovoltaic electricity generation and
aquaculture
139. Belt-driven open source circuit mill using low-
cost 3-d printer components
140. Coal with carbon capture and sequestration is
not as land use efficient as solar photovoltaic
technology for climate neutral electricity production
141. Open source low-cost power monitoring system
142. Design and construction of 36w automatic solar
street light using solar panel, charge controller, led
and with battery
143. Modeling of core loss in induction machine
HOW TO RECEIVE PROJECT MATERICAL(S)
After paying the appropriate amount (#5,000) into our bank Account below, send the
following information to
08068231953 or 08168759420
20. (1) Your project topics
(2) Email Address
(3) Payment Name
(4) Teller Number
We will send your material(s) after we receive bank alert
BANK ACCOUNTS
Account Name: AMUTAH DANIEL CHUKWUDI
Account Number: 0046579864
Bank: GTBank.
OR
Account Name: AMUTAH DANIEL CHUKWUDI
Account Number: 3139283609
Bank: FIRST BANK
FOR MORE INFORMATION, CALL:
08068231953 or 08168759420
AFFILIATE LINKS:
easyprojectmaterials.com
googleprojectsng.blogspot.com
myprojectsng.blogspot.com.ng
https://projectmaterialsng.blogspot.com.ng/
https://foreasyprojectmaterials.blogspot.com.ng/
https://mypostumes.blogspot.com.ng/
https://myeasymaterials.blogspot.com.ng/
https://eazyprojectsmaterial.blogspot.com.ng/
https://easzprojectmaterial.blogspot.com.ng/
easyprojectmaterials.com.ng
http://graduateprojects.com.ng/
http://freshprojects.com.ng/
http://info247.com.ng/
projectgraduates.com.ng
projectmarket.com.ng
projectschool.com.ng
projectstudent.com.ng
projectshop.com.ng
