Making a pinhole camera from a pringle tube

Making A Pinhole Camera from a Pringle tube!

WE USED....
Half Pringles tube
Black Sugar paper
Tracking paper
Foil
Elastic band
Scissors
Masking Tape

1 st Step First we had to cut the Pringles tube into two halves because we only needed one half which was the bottom half.

2 nd Step Then we drew a circle on the sugar paper and cut the circle out in order to place it in the Pringles tube and used blue tac.

Next we mad a hole in the Pringles tube at the tin bit using a compass in order to see the hole if not how else can we see it. The hole in the Pringles tube. 3 rd Step

4 th Step Next we covered the inside of the tube by covering the inside of the tube with black sugar paper all around inside.

5 th Step After covering, we then closed the open end with tracing paper and secured it tightly with a elastic band.

6 th Step
Finally we wrapped the Pringles tube with foil so there is a good look and it would cover the masking tape as well as the Pringles cover.

That’s how we got our pin hole camera!
Which Worked Fine!

Making a pinhole camera from a pringle tube

by Michael

Accessibility

Categories

Upload Details

Usage Rights

3 Embeds 15

Statistics

Making a pinhole camera from a pringle tube Presentation Transcript

http://michaelsartefact.blogspot.com	9
http://michaelsartefact.blogspot.co.uk	5
http://michaelsartefact.blogspot.ca	1