To install Native Instruments Traktor software for the TRAKTOR TSI controller, open Traktor's Preferences menu, select Controller Manager, click Add, import the TSI file for the controller, and verify the correct controller is selected as the In-Port and Out-Port without conflicts with other devices.

1. TRAKTOR TSI INSTALLATION INSTRUCTIONS
1. Connect the CMD Device intended to be used with Native Instruments Traktor.
2. Open the Preferences menu in Traktor and select Controller Manager.
3. Under the Device Setup section of Controller Manager, click the Add button.

2. 4. Select Import from the drop down menu.
5. Navigate to the location on your computer where the TSI file is stored and Open the file.
6. Once the TSI has loaded, look at the In-Port and Out-Port settings. Make sure the
controller you are using is selected for both.

3. 7. If you are experiencing difficulties, check the In-Port/Out-Port settings for other devices
that are installed. Verify the device has not been selected for any other controllers you
are using. Also, look at other devices which are using the All-Ports configuration. This
will cause a conflict with the two devices.