Welding requires safety precautions to avoid disastrous consequences from fires or injuries. Before welding, inspect equipment for leaks and wear, prepare the work area by removing combustibles, and ensure proper ventilation and fire extinguishers are available. Dress appropriately in flame-retardant clothing that fully covers the body, and always wear an arc mask to filter ultraviolet and infrared rays.

1. Tips for welding in a safe manner
Welding is a hard core work. It is sort of like a men’s sport. It requires at most care and intense
concentration while you are doing the process. Before you get into the technical details and
physical work of it, you must take care of safety precautions. Once you have a fair idea about the
precautionary steps, you must employ in a sequential and routine manner. “Ignore is a bliss”,
negligence is the root cause of silly mistakes. Thus see to that you avoid these two root causes
while you are taking the precautionary steps as well as get on with the welding process.
Welding is a highly flammable process. Yes, while multitasking you might make use of short
cuts to finish off the work faster. But welding is not a multitasking work nor can you apply these
short cuts upon welding. The consequences of improper neglected work can be quite disastrous.
If you have observed an expert welding any metal, you might notice him to be wearing a lot of
components before he does the task. When you are about to do the task, check your welding
components for wear and tear first. You must check for valves and hoses for any kind of
openings or possible leaks. This is very crucial, as the consequences of neglecting this issue will
be severely disastrous. A small leak can lead to a huge fire and thus in turn ruin the whole
factory, the welding apparatus used and other machines inducing a huge loss on company’s
property. In worst case scenarios it can even lead to death tolls of several employees. This incurs
a heavy loss not only on company property but as well as on the dead person’s families. Spray
the hoses and fittings with mild mixture of the dish soap and water as well. The soap creates
water bubbles and thus in turn detects leaks. This allows you to identify damaged components.
Replace them with good quality ones.
Secondly, once you are done with the mini-components, carefully inspect the area where you are
going to do the welding procedure. Prepare the area with proper preparations. Remove trash,
cardboards, flammable liquids, shop rags, and other combustible materials that might ignite from
the welding sparks. Then open doors and windows for proper ventilation of air. See to that you
also have exhaust fans facilities and switch them on. The following point is very crucial and
significant. See to that there are Fire Extinguishers around ALWAYS.
See to that you have dressed properly for the work. Use grease-free flame retardant clothing.
Also see to that the clothing fits you closely. Not too tight but not lose too to expose body parts.
It should be comfortable for you and at the same time protect you from even mild injuries.
Typically you must wear gloves, long pants, shirts with long sleeves etc to protect your skin. Use
rubber bands around loose fitting ankles and wrist cuffs.
Always wear ARC-MASK before you begin with your welding work. This filters ultraviolet and
infrared rays all times and its efficiency is 100% percent when it comes to protecting you from
harmful rays.

2. Source: http://www.everlastgenerators.com/
Keywords: Welder, Welders, plasma cutters, plasma cutter, tig welder, mig welder, Arc welder,
Diesel Generators, welding helmets, welding equipments, welding machines, motorsports, metal
cutting, welding technology, pulse tig, wire feed welder