So, if you have decided to build your own coil but don’t know how to build it and where to start, it’s OK because you have reached the right place.

1. The Ultimate How-To Guide to Build your Coil
So, if you have decided to build your own vape coil but don’t
know how to build it and where to start, Here is step by step
guide.
VapourDepot.com

2. What you’ll need?
1) Rebuildable Dripping
Atomizers (RDA)
VapourDepot.com

3. 2) Ohm Reader
VapourDepot.com

4. 3) Scissors
VapourDepot.com

5. 4) Resistance wire
VapourDepot.com

6. 5) Small propane torch
VapourDepot.com

7. 6) Thin wire cutters
VapourDepot.com

8. 7) Thin wire cutters
VapourDepot.com

9. 8) Organic cotton
VapourDepot.com

10. 9) Pliers or Tweezers
VapourDepot.com

11. Before you actually start with the coil building process,
you need to know the different types of coils you can
make at home. These include:

Single Coils

Twisted Coils

Clapton Coils

Dual Coils

12. Let's start Oxidizing the wire

Cut a 4-5 inch wire, hold its one end with a
pair of tweezers or pliers.

Now, slowly heat the wire by using torch until
it starts getting orange.

Let the wire cool and repeat the same
process by holding the other end.

Oxidizing the wire will not only make it less

13. Wrapping the coil

Place the wire at the screwdriver’s base.
Leave one end longer than the other while
wrapping the coil.

With the help of your finger, hold the wire
against the screwdriver.

You would wrap the wire about 6-8 times,
depending on the size of the RDA.

14. Installing the coil

Next, take the build deck of RDA and loose
the post screws.

Don’t remove the screws completely as they
are easy to lose but are hard to put back.

Take the coil (that is still on the screwdriver)
and position both the leads in the positive
post hole and negative post hole,
respectively.

15. Now, you are done with the coil building process;
check the structure and ensure it is built
accurately.
Happy Vaping........
Looking for a reputed vape store?
Visit
Vapourdepot.com