This slideshare aims to show you how to build smok tf rta g4/g2 tank , now the smok tf rta g4/g2 tank is in stock in vaporvaping.com

1. How To Build SMOK TF-RTA G4/G2 Tank
USA based ecig official reseller :
www.vaporvaping.com

2. Introduction
• This presentation aims to show you how to
build SMOK TF-RTA G4 Tank .

3. How to build SMOK TF-RTA G4 Tank
• 1.Before starting make sure your hands are
clean.
• 2.Taking the TF-RTA G4 deck apart.

4. Make get a Authentic TF-RTA Tank
• Make sure your TF-RTA Tank is the authentic
one .
• If you don’t have SMOK TF-RTA G4 Tank , get
the authentic one from here :
http://www.vaporvaping.com/authentic-
smok-tfrta-tank-p-465.html

5. How to build SMOK TF-RTA G4 Tank
• 3.Installing the pre-wrapped coil. Insert one
end of your coil into the up-side screw, and
the other end into the down-side screw.
• 4.Positioning and cutting the exceeding ends
of wire off. Make sure the coil is fixed and
lined up with the air hole, and also make sure
the coil is NOT touching the deck. Then cut the
exceeding ends of wire off.

6. How to build SMOK TF-RTA G4 Tank
• 5.Cutting a strip of cotton and make sure it's
just larger than the coil you built. 6.Inserting
the cotton, and placing it in the middle.
• 7.Cutting the wick at an angle and make sure
it's not too short and not too long.

7. How to build SMOK TF-RTA G4 Tank
• 8.Wet the coil with your e-liquid and adjust
the wick.
Warning: Coils must be checked for resistance
before they are fired on a device, and re-
checked periodically to ensure the resistance
remains the same.

8. How to build SMOK TF-RTA G2 Tank
• 1.Before starting make sure your hands are
clean.
• 2.Taking the TF-RTA G2 deck apart.

9. How to build SMOK TF-RTA G2 Tank
• 3.Installing the pre-wrapped coil. Insert one
end of your coil into the left-side holes, and
the other end into the right-side holes.
• 4.Positioning and cutting the exceeding ends
of wire off. Make sure the coil is fixed and
lined up with the air hole, and also make sure
the coil is NOT touching the deck. Then cut the
exceeding ends of wire off.

10. How to build SMOK TF-RTA G2 Tank
• 5.Cutting a strip of cotton and make sure it’s
just larger than the coil you built.
6.Inserting the cotton, and placing it in the
middle.

11. How to build SMOK TF-RTA G2 Tank
• 7.Cutting the wick at an angle and make sure it’s
not too short and not too long.
• 8.Wet the coil with your e-liquid and adjust the
wick.
Warning: Coils must be checked for resistance
before they are fired on a device, and re-checked
periodically to ensure the resistance remains the
same.