It’s important to remember to replace your HomePure Filter Cartridge regularly to ensure your drinking water is always clean, healthy and pure. This presentation will guide you on how to do it. Very easy!
Know more about QNET by visiting these sites:
http://www.qnet.net
http://www.qnetlife.net
https://twitter.com/QNetOfficial
https://www.youtube.com/user/QNETofficial
https://play.google.com/store/apps/details?id=com.qnet.estore.android&hl=en
https://www.facebook.com/QNETIndiaOfficial
How to Change Your HomePure Water Filter Cartridge
1.
2. Close the diverter valve
and remove the tube
from the elbow fitting.
*Be prepared for a small
amount of water that may
come out of the elbow
fitting and filter. Use a
spanner to press down the
upper ring on the connector.
3. Open the front valve and
remove the flexible pipe.
Pull out the top cover.
5. Press out the ejectors
firmly to remove the
filter adapter and filter.
*In case it is difficult to
remove the filter
because of air gap,
open and close the
valve after a few
minutes.
11. After changing the filter
cartridge, the indicator has
to be reset. Press the reset
button using a paperclip or
something similar for two
seconds to reset the filter.
12. During reset, the three LEDs
will light up simultaneously.
This means the reset is
complete.
13. Put the top cover back
on and connect the
flexible pipe to the nozzle.
15. Open the diverter and
front valve to allow water
to flow for at least 10
minutes before use.
16. Reminders
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection.
• Conforms to NSF/ANSI 53 for VOC reduction. See
performance data sheet for individual contaminants and
reduction performance.
• The estimated lifetime of the filter cartridge is 4,320 L or 12
months, whichever comes first (depending on water
quality).
17. Some Important Notes in Using
1. Follow the instructions in the manual.
2. Keep it cool.
– Only use with unheated tap water (4°C to 35°C).
3. Play it safe.
– Only use with treated metropolitan water supply (tap water).
– Only use with water with hardness that is less than 500 ppm.
– Using salt water with HomePure systems is NOT recommended.