The document outlines the lesson objectives for creating modular jack cables, including identifying and performing necessary steps and understanding their importance. It provides pre-test questions about the modular jack cable's use and components, including wire configuration and tools required. Detailed steps for creating the cable are provided, starting from preparing materials to properly placing the wires into the jack.

1. Creating
modular jack
cable
ICT/CSS 10
Browser
12:01 PM
Page 01

2. What You Will Learn
Lesson
Objectives:
1. identify the steps in
creating modular jack
cable.
2. perform the steps in
creating modular jack
cable.
3. appreciate the
importance of creating
modular jack cable.
12:01 PM
Page 02

3. Pre-Test
Start
Direction: Read each statement
below carefully. Write T if the
statement is TRUE. Write F if the
statement is FALSE.
12:01 PM
Page 03

4. Modular jack cable is used for
telephone systems, data networks,
and lowspeed serial connections.
Pre-Test
One
12:01 PM
Page 04

5. There are 6 wires to secure inside
the modular jack.
Pre-Test
Two
12:01 PM
Page 05

6. Punch down tool is use to secure
each wire to the slot of modular jack.
Pre-Test
Three
12:01 PM
Page 06

7. The modular jack consists of “A” and
“B” configurations.
Pre-Test
Four
12:01 PM
Page 07

8. LAN tester is use to check the
connectivity of modular jack cable.
Pre-Test
Five
12:01 PM
Page 08

9. Page 09
used for telephone systems,
data networks, and low-
speed serial connections.
Modular jack cable
12:01 PM

10. Steps in Creating
Modular Jack
Cable
Browser
12:01 PM
Page 10

11. STEPS
Page 11
Picture:
1. Prepare
the tools
and
materials.
12:01 PM

12. STEPS
Page 12
Picture:
2. Strip
approximately
1.5 inches of
jacket from
the twisted-
pair cable.
12:01 PM

13. STEPS
Page 13
Picture:
3. Separate the
twisted wire
pairs from each
other; then
untwist each
pair. Straighten
wire ends out as
much as
possible.
12:01 PM

14. STEPS
Page 14
Picture:
4. Remove the
jack's protective
cap, then
choose between
“A” and “B”
configurations.
12:01 PM

15. STEPS
Page 15
Picture:
5. Place all 8
wires into the
center of the
jack, divert the
wires into their
correct slots.
12:01 PM