1. Pat’s Petunias : You have been called in as a network consultant by your cousin Pat, who operates a successful mail-order flower business. She is moving to a new office and wants to install a network for her telephone operators, who take phone calls and enter orders into the system. The number of operators working varies depending on the time of day and day of the week. On slow shifts, there are usually only 10 operators, whereas at peak times, there are 50. She has bids from different companies to install (1) Wi-Fi or (2) a switched Ethernet 100Base-T network. She wants you to give her some sense of the relative performance of the alternatives so she can compare that with their different costs. What would you recommend? Use the format below to begin working on the report. Given : Assumptions: Comparison: WiFi – IEEE 802.11 100Base-T Switched Ethernet Performance: Discuss reason for collisions How would you solve collisions? How can you give a good throughput? Performance: Discuss how switched Ethernet works- overcomes collisions? Discuss dedicated data rate per device Cost: What are some of the cost components? Include # of devices, device cost, labor costs, operational costs if any. You may pull out numbers from the Internet. Please cite your sources Cost: What are some of the cost components? Cost: What are some of the cost components? Include # of devices, device cost, labor costs, operational costs if any. You may pull out numbers from the Internet. Please cite your sources Security: Security issues and how you would over come them Security: Security issues if any . Pros and Cons Summary Pros and cons summary Suggestion based on the analysis in the above table: Solution I think she should consider Wi-Fi because the data rates for Wi-Fi have increased substantially with the introduction of 802.11n, so they are similar to the data rates offered by 100Base-T wired Ethernet. Wi-Fi is considerably cheaper than wired Ethernet because the largest cost of LANs is not the equipment, but in paying someone to install the cables. The cost to install a cable in an existing building is typically between $150 and $400 per cable, depending on whether the cable will have to be run through drywall, brick, ceilings, and so on. The cheapest point at which to install network cable is during the construction of the building; adding cable to an existing building can cost significantly more. Additionally, it’s more convenient for anyone walking or driving within the range of the AP (access point) can begin using the network. IV. Tom’s Home Automation Your cousin Tom runs a small construction company that builds custom houses. He has just started a new specialty service that he is offering to other builders on a subcontracting basis: home automation. He provides a complete service of installing cable in all the rooms in which the homeowner wants data access and installs the necessary networking devices to provide a LAN... A)mail-order flowerbusiness. She is m.