1. Samuel Sahlie
Ph# 248-453-4959
E-mail sammoja10@yahoo.com
Summary:
 Engineering electronics test technician with years of experience. Committed to provide
quality and consistent technical support.
 Tested and assembled industrial, Automotive, Biomedical and commercial circuit
boards, with a thorough understanding of practical electronics concepts like, reading
schematics, pneumatics & wiring Diagrams.
 Proficient in quality assurance procedures, testing cable harnesses and integrated units.
Highlights:
 Good written & communication skills
 Accurate reporting of test & measurement results
 Use of AC/DC power and control systems
 Translating assembly drawings and schematic diagrams
 Efficient troubleshooting skills
 Testing with the use of Labview windows systems
 Reliable in the use of Microsoft Excel, Word and Power Point etc.
Accomplishments:
Worked with a variety of circuit boards under different projects over the past 22 years. During
these times my responsibility includes, to collect data in written and electronic formats and
communicate with test engineers. I have the training & experience of Validating PCB’s in
Heat & Cold chambers under controlled temperature. I properly trained new and current
employees for both setting up and debugging all industrial, commercial and biomedical
and highly graded boards like military PCB’s.
Experience:
Jabil circuits co. Auburn Hills, MI 11/2014 - 09/2015
Test technician
 Calibrating and functional testing the ST100 sterilizer medical equipment.
 Function pre and post burn test of medical instrument test analyzers.
Roush inc. 10/2014-11/2014
Crimping and wire harness.
 Building wires into Molex type power connectors for Auto parts by crimping the high
durability spring clips and the rugged ML-XT connection system.
Adco Circuits Rochester Hills, MI 03/1997- 04/2014
Senior Test Technician
 Electronic test equipment setup (function generators, power supplies).
 Troubleshoot electrical/electronic control circuits using DMM and Digital scopes.
 Thoroughly inspected and repaired program systems components.
 Read and interpreted schematics, used test equipment to input signals and measure
corresponding outputs.
 Ran operational tests on systems and equipment to reinforce proper processes and
remedy malfunctions.
Detects Inc 07/1995-07/1996
Assembler/solder and troubleshooter
 Assembled electronic equipment, crimping, wiring and soldering of PCB components that
goes into the boats engine systems.
 Performed routine and scheduled troubleshooting, and repair using Meters.

2. X-Rite Inc. 10/1994-07/1995
Test technician and solder
Testing PCB’s in heat & cold chamber and test in bench outside of the chamber.
Installed PCB’s inside a unit after a pass confirmation. Assembling, soldering &
troubleshooting are also part of the job.
Gentex Inc. 09/1993-07/1995
Assembling/Soldering/Testing
 Worked as an electronics board assembler and did a lot of soldering auto parts that goes
into a car’s rear-view mirror.
Robert Shaw Inc. 01/1992-09/1993
Sequence machine operator/Assembler
 Assembling, soldering and stuffing components to PCBs. As a lead sequence machine
operator, have the responsibility of the accuracy and placement of the components in the
right position and identification.
Education:
Grand Rapids Community College Aug.1989- May 1991
Associate of Applied Science: Electronics Technology
Grand Valley State University Aug. 1991- May 1992
Minor in Basic Programming and Automation
Certificate of training to perform inspection operations, and soldering in accordance with IPC-A-
610B and ANSI/J-STD-001A
Advanced soldering and Basic Soldering certification from Jabil circuit co.