The industrial refrigerating sliding doors are designed for cold rooms that must retain temperatures between 0 °C and -40°C (32°F and -104°F). These top-quality doors are specifically used for the meat, fishing, vegetable, fruit, dairy and logistics industries. An important aspect of Kaviflex’s refrigerating sliding doors is the simplicity and ease of assembly and use.

1. REFRIGERATING SLIDING DOOR KSC
WHAT IS IT, WHAT IS IT FOR AND HOW TO INSTALL IT

2. The industrial refrigerating sliding doors
are designed for cold rooms that must
retain temperatures between 0 °C and
-40°C (32°F and -104°F).
These top-quality doors are specifically
used for the meat, fishing, vegetable,
fruit, dairy and logistics industries.
An important aspect of Kaviflex’s
refrigerating sliding doors is the simplicity
and ease of assembly and use.
WHAT IS THE KSC REFRIGERATING SLIDING DOOR

3. HygieneAir tightness
DurabilityPIR isolationDesign
Fireproof
ADVANTAGES

4. Level Hammer
Screwdriver
Ratchet wrench
(cups #17 & #19)
INSTALLATION: TOOLS I
Electric
screwdriver
Jigsaw
Polyurethane
foam
Measuring
tape

5. Japanese
finial
Japanese finial’s
embellisher
Pin with
nuts
Drill #9
INSTALLATION: TOOLS II
Kaviflex
screws I
Kaviflex
screws I

6. 1. We mark the width and height
measurements of the panel door
2. We count 3 cm more of the jigsaw’s
light on each side
3. We place the frame in its position
4. Check the measurement
a. Option 1: Before installing the
counter frame, we proceed to
inject polyurethane foam.
b. Option 2: After installing the
counter frame, we proceed to
inject the polyurethane foam.
5. Place the counterframe in position
6. Check the frame’s level
7. Set the panel and the frame
8. Proceed the same with laterals
INSTALLATION: HOW TO INSTALL THE FRAME

7. 1. Half-light part +260: We place the
closing piece on the frame
2. Drilling and screwing to the wall
3. We unite the two pieces of the guide
4. Check the guide’s level
5. We set the guide and unite with the
hasp
6. Drill through the upper part of the guide
until it pierce through the panel
7. Put the japanese finials and screw
INSTALLATION: HOW TO INSTALL THE GUIDE

8. 1. Place the cars in their position
2. Raise the door to place it on the guides
3. Screw the flanges to the sheet
4. Attach the skid to the sheet
5. Advisable: Pierce through the panel
6. Install the lateral guide checking the level
and screw the panel
7. Place the protective bellows in its position
8. Place the covers and embellishers in their
position
INSTALLATION: HOW TO INSTALL THE SHEET

9. In this video we show you step by step how to carry out this installation:
INSTALLATION: VIDEO

10. If you want to know more, contact us!
www.kaviflex.com