1. Tim Bradshaw
Inola OK. bzb05@tds.net Mobile (918) 504-3200
https://www.linkedin.com/pub/tim-bradshaw/89/310/375
Professional Experience
Nupar Mfg. (Division of Baldor Electric, an ABB group) 1997 to Present
Liaison Engineer: 2008-Present
SAP duties including TDR’s (Technical Data Release) processing of all prints, New parts,
changes, BOM, and routing of all parts.
AutoCad Design and Drawing Revisions.
AutoCad Layout of Stator Band flat patterns, Mylar templates, and CNC (SmartCam Software)
programming generation.
— Mylar/NC code verification (Time and Scrap Reduction)
Turret Press operations, downloads, maintenance and tooling ordering and supervision.
— Tooling maintenance (60% cost savings per unit)
Stator Band equipment knowledge of operations, fixture design, & trouble shooting.
— Involved in implementing new press line (25% faster)
Setup, CNC programs and maintaining of the FOBA Laser & CIM Embosser
— Implemented New CIM Embossers and fixtures (Cost and Time saving)
Spreadsheet creation, maintain, input of (Value Hunt Administration)
— Administrator of cost saving program
Laser & Emboss Operator: 2003-2008
Run production nameplates on FOBA Lasers and embossers for 5 Baldor plants
— Laser and Emboss trainer
Quality Control &Auditor: 1997-2003
1st piece, daily inspection, Calibration, and Auditor
— Involved in implementation of Air Gages (cost and accuracy)
GeophysicalResearch Co.(GRC) 1988-1997
Electronic and Mechanical Inspector:
1st piece, daily, and incoming inspection
Setup and testing of customer’s computer and tooling equipment for outgoing.
Field troubleshooting of customer equipment
Education
OSU Institute of Technology, 1987 – Associates Degree
Drafting I & II, AutoCad 2011
Lean Mfg, 5S, ISO 9000 & Auditor, Six Sigma, SAP, Microsoft