This document summarizes the specifications of a digital multimeter. It can measure AC/DC voltage and current, resistance, frequency, duty cycle, diode, capacitance, temperature, and more. Measurements have a resolution of up to 0.0001 units. It has features like peak detection, data hold, and fast/slow measurement rates. General specifications include an operating temperature range of 0-50°C, drop and vibration resistance, 1 year calibration period, and power from batteries with auto-off. Safety standards include IEC 61010-1 for categories II and III.
Call Girls In Sikandarpur Gurgaon ❤️8860477959_Russian 100% Genuine Escorts I...
189 specification- www.ttbvs.com
1. 189
(产品型号展示优化词:Logging of True RMS digital multimeter with
Accuracy: +-0.02% 189)
Features:
l Three measurement rate:
FAST, SLOW, SMOOTH, the
fastest refresh rate of
simulation bar: 14 / sec
l Manual range or automatic
range selection
l Measuring data show that
hold functional (DIS_HOLD)
and automatically hold
functions(AUTO_HOLD)
l Peak measurements, 500us
peak sampling capture,
capable of capturing crest Pulse
l AC voltage and AC current are true rms measurement, AC voltage bandwidth 20Hz-
100KHz, AC current bandwidth 20Hz-30KHz
Specifications:
Measurements Range Measuring
range
Resolution
DCV 5.0000V 0.0001V Input impedance:
10MΩ50.000V 0.001V
500.00V 0.01V
1000.0V 0.1V
DCmV 50.000mV 0.001mV Input impedance:
approx. 100MΩ
500.00mV 0.01mV
2200.0mV 0.1mV
ACV 5.0000V 0.0001V Input
impedance:
CF<3
187:
50.000V 0.001V
www.ttbvision.com
2. 10MΩ /
50pF
20Hz~
30kHz
(10~
110%
Range)
189:
20Hz~
100kHz
(5~
110%
Range)
500.00V 0.01V
760.0V 0.1V
ACmV 50.000mV 0.001mV Input
impedance:
1MΩ / 50pF
500.00mV 0.01mV
OHM 500.00Ω 0.01Ω Open circuit voltage
<2.5V
5.0000KΩ 0.0001KΩ
50.000KΩ 0.001KΩ
500.00KΩ 0.01KΩ
5.0000MΩ 0.0001 MΩ
50.000MΩ 0.001 MΩ
500.0MΩ 0.1 MΩ
DCA 5.0000A 0.0001 A Voltage Drop <0.04
V/A
20.000A 0.001 A
DCmA 50.000mA 0.001mA Voltage Drop
<1.8 mV/mA
500.00mA 0.01 mA
DCuA 500.00uA 0.01 uA Voltage Drop
103uV/uA
5000.0uA 0.1 uA
5.0000A 0.0001 A
ACmA 50.000mA 0.001mA
500.00mA 0.01 mA
ACuA 500.00uA 0.01uA
50000uA 0.1uA
FREQ 9.9999Hz 0.0001Hz
www.ttbvision.com
3. 99.999Hz 0.001Hz
999.99Hz 0.01Hz
9.9999KHz 0.0001KHz
99.999KHz 0.001KHz
999.99KHz
0.01KHz
9.9999MHz 0.0001MHz
99.999MHz 0.001MHz
DUTY 0.1%~99.9% 0.1% 0.5Hz~1KHz,
Square Wave
PULSE
199.99ms 0.01ms
1999.9ms 0.1ms
DIODE 2.2000V 0.0001V Open circuit voltage:
<3.5V
Short circuit:0.8mA
CHCNT 500.0Ω 0.1Ω Open circuit voltage:
<3.5V
Short circuit:<0.8mA
Short alarm:approx.
<20Ω
Open alarm:approx.
>120Ω
CAP 9.999nF 0.001nF
99.99nF 0.01nF
999.9nF 0.1nF
9.999μF 0.001uF
99.99μF 0.01uF
999.9μF 0.1uF
9.999mF 0.001mF
99.99mF 0.01mF
TC R -40°C~
1760°C
1°C ITS-90
S -40°C~
1760°C
www.ttbvision.com
4. K -270.0~
1370.0
0.1°C
E -270.0~
720.0
0.1°C
J -210.0~
850.0
0.1°C
T -270.0~
400.0
0.1°C
N -270.0~
1300.0
0.1°C
B 400~1800 1°C
RTD Pt100 -200.0~
850.0
0.1°C Pt100-385
Pt1000 -200.0~
630.0
0.1°C
Other Features:
l DC Voltage measurement
CMRR:50Hz / 60Hz ≥ 120dB
SMRR:50Hz / 60Hz(Rs=1kΩ) ≥ 80dB
l AC Voltage measurement
CMRR:50Hz / 60Hz(Rs=1kΩ) ≥ 80 dB
A residual reading with input shorted, will not affect stated accuracy above 5 % of range.
l OHM measurement
For relative humidity greater than 70 %, resistance accuracy is 0.5 % over 1 MΩand 2.5 %
over 10 MΩ.
l Internal temperature compensation sensor RJC:
temperature range: -10 ~ 50 , compensation error ≤ ±℃ 0.5 , compensation time for 10℃
seconds each time
l Maximum voltage between any Terminal and Earth Ground :
1000V DC / AC rms
Fuse protection for mA input: 500 mA / 250V FAST fuse
fuse protection for 20A input: 20 A / 250V FAST fuse
Can be as high as 20 A continuous measurement of the current, if the signal detected in 10
A ~ 20 A of maintaining maximum of 30 seconds, then specified the need to increase the
accuracy of 0.5%
l Real-Time Clock
≤ ± 1min / 1month
Temp. Influence 50 ppm per C
l Measured rate
Functional range Measuring rate
www.ttbvision.com
5. FAST SLO
W
SMOOTH
DC voltage and current 14 7 1
AC voltage and current 14 / 1.8
Resistors, diodes, on-off 7 / 1.8
General Specifications:
l Operating Temperature and Humidity
0 to 50oC,(no condensation ≤10oC) ≤ 85%RH
l Storage Temperature and Relative Humidity
-20oC to 60oC,≤90%RH
l Altitude
2000m max. above sea level
l Rated transient over-voltage
6KV(1.2*50us)CAT , CAI , CATⅠ Ⅱ Ⅲ peak measurement
l Vibration and Shock
Random 2g, 5 to 500Hz
1 meter drop test
l Period of calibration and warm-up time
Accuracy is specified for a period of one year after calibration or other
Warm-up time is 10 minutes or other
l Display and LED
* LCD:36.3×68.0mm
* white LED,able to set time 0~9999S
l Supply
* 4 x 1.5V Alkaline batteries supply
* 4 x 1.2V Ni-Hi batteries supply
* Auto Power-off:able to set time 0~9999minutes
l Safety Standards
IEC 61010-1, 2000
Overvoltage category III (Max. input voltage:AC/DC600V)
Overvoltage category II (Max. input voltage:AC/DC1000V)
Pollution degree 2
l Weight and Size
205 × 95 × 42(mm) ,approximate 500g
www.ttbvision.com
6. FAST SLO
W
SMOOTH
DC voltage and current 14 7 1
AC voltage and current 14 / 1.8
Resistors, diodes, on-off 7 / 1.8
General Specifications:
l Operating Temperature and Humidity
0 to 50oC,(no condensation ≤10oC) ≤ 85%RH
l Storage Temperature and Relative Humidity
-20oC to 60oC,≤90%RH
l Altitude
2000m max. above sea level
l Rated transient over-voltage
6KV(1.2*50us)CAT , CAI , CATⅠ Ⅱ Ⅲ peak measurement
l Vibration and Shock
Random 2g, 5 to 500Hz
1 meter drop test
l Period of calibration and warm-up time
Accuracy is specified for a period of one year after calibration or other
Warm-up time is 10 minutes or other
l Display and LED
* LCD:36.3×68.0mm
* white LED,able to set time 0~9999S
l Supply
* 4 x 1.5V Alkaline batteries supply
* 4 x 1.2V Ni-Hi batteries supply
* Auto Power-off:able to set time 0~9999minutes
l Safety Standards
IEC 61010-1, 2000
Overvoltage category III (Max. input voltage:AC/DC600V)
Overvoltage category II (Max. input voltage:AC/DC1000V)
Pollution degree 2
l Weight and Size
205 × 95 × 42(mm) ,approximate 500g
www.ttbvision.com