i-Leaktek 6600 Leak and Seal Strength Tester is designed for determination of seal strength and seal performance test of various heat sealed flexible package and sterilized package, seal performance test of pilfer-proof closures, quantitative testing of leak characteristics, compression resistance, capsule disengaging strength, cap body joint strength, seal-edge seal strength and butting strength of flexible tubes, and testing of anti-compression, seal performance and burst resistance of the bottles.

1. www.labthinkinternatio
nal.com
i-Leaktek 6600 Leak and Seal Strength Tester---Medical Blister Test
Scope
i-Leaktek 6600 Leak and Seal Strength Tester is designed for determination of seal strength and seal performance test of
various heat sealed flexible package and sterilized package, seal performance test of pilfer-proof closures, quantitative
testing of leak characteristics, compression resistance, capsule disengaging strength, cap body joint strength, seal-edge seal
strength and butting strength of flexible tubes, and testing of anti-compression, seal performance and burst resistance of the
bottles.
Test Procedures
A: Power the instrument on and warm up for at least 30 minutes. Prepare the specimen as required. The number of
specimens should be not less than 5 and should be free of visible imperfections. Then mount the specimen as shown in the
figure below.

2. www.labthinkinternatio
nal.com
B: Set up test parameters and start the test.

3. www.labthinkinternatio
nal.com
C: View test curve and test report. Continue to perform tests by repeating above procedures if necessary.
Labthink International Inc.
www.labthinkinternational.com
200 River's Edge Drive
Medford, MA 02155 map
Phone: 617-830-2190
Fax: 781-219-3638