Grab the simple Canon Pixma wireless printer setup guide from our tech experts. Contact us to get instant troubleshooting guidance.

1. CANON PIXMA WIRELESS PRINTER SETUP
• The Power button is available on the top of the printer’s control panel.
• Use the Power button to change the printer to the active state.
• Wait until the control panel displays.
• Go to the Setup icon and click Maintenance.
• Select the Wireless LAN Setup icon under Maintenance for the Canon Pixma
wireless printer setup process.
• Search for the access point and begin the connection process.
• Choose the Canon printer option from the list of available devices.
• Mention the password in its tab. The password is available in 8-64 characters.
• Press OK after the process completes.
• A message displays as the printer is connected to the access point.
• To install the driver, click the Next option.
• Wait until the Setup Guide Installation window pops-up.
• Connect the printer to an access point to begin the installation process.
• Select the Next option and choose the place of residence option.
• Customize the driver settings and click Next.
• Read and Agree to the Terms and Conditions mentioned on the screen.
• The driver installs on the system. The installation progress status displays on the
screen.
• End the installation process by clicking Complete.
• After completing the process, the printer name displays in the list of available
devices.
• After a while, the printer prints a test page to check if the driver is installed correctly.
Contact our tech experts to know more about Canon Pixma wireless printer setup
process.

2. WPS CONNECTION METHOD
• To set WPS, you have to satisfy some conditions. Check if the access point has a
physical WPS button available and whether your network uses Wi-Fi Protected
Access or WPA2 security protocol.
• After checking the above conditions, start the Canon Pixma wireless setup process.
• Switch on your printer and make sure that the router features a WPS button. Press it
when required.
• Press & hold the Wi-Fi button on the printer control panel. Continue the action until
the ON lamp starts to blink.
• Now, press the Back button and then the Wi-Fi button for the Canon Pixma wireless
printer setup process.
• Ensure that the Wi-Fi lamps flash quickly and the ON lamp slowly.
• Once the lights start to blink, then go to the access point & press the WPS button
within the two minutes.
• Now, on the printer, check if the blue light of the Wi-Fi lamp continues to flash while
searching for the network, and the Power & Wi-Fi lights flash when the printer
connects to the access point.

3. • If the lights stop flashing, it means that the WPS connection set up is successful.
Assure that after the successful connection setup, the Wi-Fi & the ON lamp are lit.
• Now, you can perform the print, scan, copy, or fax operations from your printer,
once the Canon Pixma wireless printer setup process is over.
STANDARD CONNECTION METHOD
• The steps given below will help you understand how to connect your printer to the
computer using a Canon Pixma standard connection method.
• Tap the Home button on the control panel of your printer.
• Use the up and down arrow keys to choose the WLAN Setup icon.
• Press the Function Button available on the left side of the panel.
• Once the connection is established, the Wi-Fi lamp will be lit in blue color.
• The Canon printer will now start searching for any access points nearby.
• Press the Stop/Reset button and hold it for a few seconds.
• Choose the Standard setup option and tap OK.
• Canon printer will now search for wireless networks available nearby.
• With the help of the arrow key, choose the access point and press OK.
• In case you are unable to find your network, then press the Left Function button to
start searching again.
• Specify the password of your network in the next screen that appears. The
password is case-sensitive, so make sure you enter the correct password.
• The security key can be entered using the arrow keys.
• Press Done after successfully entering the password.
• You can also edit the password by tapping the OK option.
• Tap the Left Function button to finish click more.