2. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
A: Yes it is. The electrical pulse is 320v, which is very high,
but the duration of the pulse is extremely short. The pulse
lasts about half a millionth of a second. This stresses the
cell walls and assists the plasma.
Q: I can't feel anything in contact mode. Is this normal?
3. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Why does my generator stop responding when I use it
with Spooky Central? I am using a USB filter cable.
A: High power & high frequency signals are emitted from Spooky
Central. These are affecting your generator. The USB filter cable and
high quality Spooky Central BNC cables prevent most of the
frequencies from entering the generator. However, the generator's
body is made from metal, and this is picking up frequencies from the
white high voltage cable and the tube. Please have the white high
voltage wires and plasma tube as far from your generator as possible.
4. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Can you get me a power vs. distance vs. frequency curve for
the plasma tube? Your claim is it is more powerful than the other
units but only works to about 2 cm. I successfully used the
GB4000 MOPA at about 2 meters.
A: I am not sure who gave you this information. Our unit works
much further than 2cm! We could detect a strong signal 60m
away through concrete walls. The tube has about 40 watts
applied. All of this power is used to treat the pathogen, not
provide a carrier that has no function apart from lighting the tube
and causing frequency fatigue. Beyond a few cm the field of all
plasma devices changes from near field to far field. The near field
is more effective. This is why we recommend having the tube
close or even touching.
5. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: What is the frequency range of Spooky Central?
A: The plasma tubes generally ionise at 80 kHz but we allow a margin
for tube manufacturing variables and different operating ambient
temperatures. Spooky Central will actually work down to 0Hz but the
tube ionisation is so brief that it cannot be detected. The maximum
frequency is about 3.6 MHz, but again this depends on many factors
like the length, spacing and orientation of the white wires feeding the
tube, tube type and more. Adding a high speed gate (about 20 Hz)
increases the operation range. We have run a Spooky Central at 8
MHz using a short wire and 20 Hz gating.
6. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: What makes you say the near field is more effective?
A: That is the field type used by doctors when they used the
original Rife machines. They found that beyond several feet the
results were not so good. The signals can still be detected but the
field starts turning into far field. Plasma produces two related
fields. The one that does the really heavy lifting is the near-field,
and this extends six inches from the tube in all directions. After six
inches, it becomes far-field, which isn't as effective as near-field,
although it still works efficiently enough to disinfect and clear mold
from a home. So it still works on the body, just not to the same
extent and power as near-field.
7. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: If running a Spectrum sweep will there be limitations on the
maximum WCM values that will be used with the plasma
portion of Spooky Central? I'm wondering how well the
amplifier will be able to amplify the many simultaneous
frequencies that are produced by the spectrum sweeps in
order to ensure EACH frequency has enough amplitude to be
effective via the plasma.
A: We have run many spectrum sweeps in Spooky Central. The
amplitude of each spectrum frequency is high. Most digital
spectrum analyzers don't pick up the frequencies since they use a
bin sampling method but the waveform wavelengths conform
exactly to the set parameters of the Spectrum. A low wave cycle
multiplier seems most beneficial for rapid results to be seen.
8. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
The BXBY waveform, which is actually a custom Spectrum with a wave
cycle multiplier of 2 has particularly strong signal at both frequencies
since the WCM is 2. Most plasma Rife machines waste power at the
carrier frequency. Only 2% of the total power to the plasma tube hits
the target when using their recommended settings for cancer. Though
our unit is only 40 watts, it does apply a true 40 watts at the target
frequency.
We have tried not to compare our unit to any other commercial device,
but many people seem to think more watts is better. Much as you
asked the effective distance of our tube. Royal Rife and subsequent
doctors touched his patients with his phanotron tube whilst treating
them. His machine sent around 45 watts to the tube. We have modeled
our machine around his.
9. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Is the plasma tube powerful enough to treat all the
body or just parts?
A: The plasma tube is powerful enough to treat the whole
body, though to gain the most benefit from the frequencies
we suggest you treat portions of your body at a time, or
sweep the tube across your body.
10. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Is the plasma tube UV shielded? I'm treating
important pathologies in the area of the eyes, and
need to know that no harmful UV radiation is
coming out of there.
A: Quartz glass is transparent to ultraviolet light, and emits
large amounts of ozone and UV light as a result. Our plasma
tubes do not contain poisonous Mercury and therefore emit
very little ultraviolet light.
11. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Is it possible to attach other plasma tubes from other
companies?
A: Plasma tubes from other companies should work with
Spooky Central provided they have internal electrodes and the
ionising voltage is not too high. The TrueRife machines are
simple car coil devices that operate at extremely high voltages.
It is possible these tubes will not work with Spooky Central.
12. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: It is my understanding from your prior reports, that this
plasma tube has the ability to simultaneously emit dozens
of frequencies at the same time, rather than sequential
frequency emission, one by one, as is the current limitation
when just using the hand bars, or the foot plates, etc.
A: Spooky Central can run a plasma tube with the Spectrum
waveform. This waveform can contain many equidistant
frequencies that are simultaneously broadcast. Further details of
Spectrum are in the Spooky User's Guide.
13. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: What is the gauss power of the PEMF coils on surface
and what is the Hz range that the coils cover?
Would you say it is just good as the most expensive ones
on the market?
A: The coil output of Spooky Central is a short spike as
opposed to long duration signals, so it cannot be compared to
other systems. The coils are rated at 200 gauss but the field
strength may be higher. We are currently investigating the use
of more powerful coils. The frequency is a fixed 100 Hz and the
pulse duration 69 microseconds.
14. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Apart from precautionary measure of not using PEMF for
those with pacemakers, I have read that it should not be used
with patients who have metal vascular clips. These clips hold
blood vessels intact and the force of the magnet may pull
these clips and misalign the blood vessels or even rupture
them. Please keep this in mind.
A: Most vascular clips are ok for use with MRI scanners that are
much more powerful than Spooky Central's coil output since they
are made from metals or materials that are not magnetic. Some
clips are made from ferrous materials. If you have these then our
advice is to avoid MRI scans and PEMF use unless instructed to
do so by a trained and registered medical professional.
15. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Where is the best place to set up Spooky Central? Can I set
it up in an open area like our living room which flows to
kitchen and dining room? I told my husband to set it up in our
bedroom. I hope the metal lampshades will not affect it or vice
versa. Can sparks jump to the metal?
A: Spooky Central can be safely used in almost every room, except
rooms that are damp such as the bathroom or laundry. Sparks will
not jump from nearby metal objects. The bedroom is an ideal place
to position Spooky Central since overnight treatments will then be
possible.
16. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Why does my Spooky Central no longer light the tube?
A: There can be many reasons. The most simple solution is to
ensure the white cables is kept apart and there are no loops in
the cable. Software settings can also cause problems. We
suggest using the Spooky Central presets to guarantee best
results.
17. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: What is the max time I can use the plasma continuously?
A: There is no maximum time. It can be used overnight, though we
suggest shorter day treatments. This allows you to monitor your own
health condition whilst using Spooky Central.
18. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: Why can't I hear the ultrasonic speaker when I run
the generator at 3000 Hz?
A: The ultrasonic speaker runs at a slower frequency than the
generator input. The input frequency is divided by 16 for high speed
operation and 256 for low speed operation. At high speed setting
an input of 3000 Hz will make the ultrasonic speaker run at 187.5
Hz. You will hardly hear it. To make the ultrasonic speaker run at
3000 Hz set the generator frequency to 3000 x 16 = 48000 Hz.
19. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Q: I cannot seem to get the central contact mode to work.
What's more interesting is the only way to get response via
contact mode through the central is when I plug into the
coils out (NOT the contact out)!
A: It is perfectly normal that you don't feel anything. Spooky
Central works entirely differently from any other contact device.
An immensely powerful 320v (or more) is fired out for less than
half of a millionth of a second. If the duration was a second it
would throw you across the room! This extremely short, intense
voltage is devastating for viruses, bacteria and parasites, but
harmless for us since the pulse is so brief.
20. Official Support Website: www.spooky2.com
Official Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.com
or service@spooky2.com
Thank you!