CALL ON ➥8923113531 🔝Call Girls Adil Nagar Lucknow best Female service
Upload a presentation to download Open shortest path first (ospf)
1.
2.
3. • OSPF Open Shortest Path First (std protocol)
• Intra domain routing protocol based on
link-state routing protocol
• It uses SPF or dijkistra algorithm
• Unlimited hop count
• It’s a classless routing protocol
• Only equal cost load balancing
• Provides authentication of routing messages
• Administrative Distance 110
4.
5. • Metric known as cost, cost depends on BW
• Lowest cost is the best path
6. Loopback interfaces are logical interfaces,
which are virtual, software-only interfaces;
they are not real router interfaces
Using loopback interfaces with your OSPF
configuration ensures that an interface is
always active for OSPF processes
Configuring loopback interfaces when using
the OSPF routing protocol is important, and
Cisco suggests using them whenever you
configure OSPF on a router
7. • This is an IPv4 address used to identify a
router
• 3 Criteria for deriving the router ID
i. Administrator can manually assign Router
ID using router-id command
ii. If router-id command is not used the
router chooses the highest IP address
among the loopback address
iii. If no loopback interfaces are configured
the highest IP address of any active
interface is used as router-id
8. OSPF network can be divided into groups
called areas
Areas are identified by an area ID
An area is a logical collection of OSPF
networks, routers and links that have the same
area ID (identification)
Areas limit the scope of route information
distribution
Benefit of creating areas is to reduce the
number of routes to propagate by filtering the
summarization of routes
9. All network inside an area must be connected
At the border of an area, special router called
Area Border Router (ABR)
ABR summarizes the information and send to
other areas
The router placed at the boundary of a single
AS is called Autonomous System Border Router
(ASBR)
10. A backbone area which combines a set of
independent areas into a single domain
The backbone has reserved area ID 0.0.0.0. The
OSPF backbone area is also known as area 0
The backbone acts as a hub for inter-area
transit traffic and the distribution of routing
information between areas
Each non-backbone area must be directly
connected to the backbone area
11.
12. OSPF uses a DR (Designated Router) and BDR
(Backup Designated Router) on each multi-
access network
When a router is not the DR or BDR it’s called
a DROTHER
Network administrator can configure any
router as DR or BDR changing the priority
value
A router with priority ‘0’ will never be
selected as DR or BDR
13. Routing configuration
(config)#router ospf <process id>
(config-router)#network <NA> <WCM> area
<area-id>
Checking configuration
Router#show ip ospf interfaces
Router#show ip route
Router#show ip ospf neighbor
