How to update your Bartec WRT400 TPMS Tool!

3. As you are aware of by now
Bartec has released software
Revision 39!
This tutorial will show you how to
update your tool to the latest and
greatest software Bartec has to
offer

4. First make sure your
Tool is powered off
And NOT plugged
Into your PC

5. Go to our website at
www.bartecusa.com and click the
log in tab as shown below.

6. Log into your account using
your user name and
password

7. Click on the tool
management button

8. Locate the tool you are trying to
update by serial number and click the
download button for that tool

9. When this window appears click
the save button

10. At this screen click save…DO NOT CLICK
OPEN here

11. Once you have saved your file
you can close or minimize
your web browser and your
file will appear on your
desktop

12. Now you want to put your tool in program mode by
pressing and holding the enter button and pressing the
green power button at the same time

13. Your tool screen
should read NO
UPDATE FILES
FOUND

14. Insert the USB cord into your PC then
insert the other end into your tool…The
USB port for your tool is located on the
right side

15. This removable disk screen should pop up on
your computer screen containing a file labeled
PROG.BIN
If the removable disk window doesn’t launch click on the
start key at the bottom of the screen and open the
removable disk located under the devices with removable
storage tab

16. Click and drag or copy and paste
the update file into the removable
disk window

17. Once you move the update file to the
window it will automatically begin to
download the program to your tool

18. Within seconds your computer will
show it is downloading the file to
your tool…this process will take
around ten seconds to complete

19. During this process your tool
screen will read NO UPDATE
FILES FOUND
Once the downloading process
is complete remove the USB
cord from the tool and press
the test button located in the
middle of the tool

20. Your tool will read
VERIFYING FILE

21. Your tool will
then say
VERIFY
COMPLETE
ERASING
PROGRAM

22. Your tool will then begin
programming and show
you the status
This process will
take about thirty
seconds

23. When your tool is done
programming it will shut
itself off

24. Power your tool back on by
pressing the green power
key and under the Bartec
logo it should say the new
software level is 39