it is a project on heart attack detection using Arduino. it helps many people to save their lives. it is same as first aid kit.

1. TRACK YOUR STROKE

2. INTRODUCTION:
Good health is one of the global challenges for humanity. The prime goal is to develop
a reliable patient monitoring system so that the healthcare professionals can monitor
the patients, who are either hospitalized or executing their normal daily life activities.
Recently, the patient monitoring systems is one of the major advancements because of
its improved technology. They need to visit the patient's ward for necessary diagnosis
and advising. There are two basic problems associated with this approach. Firstly, the
healthcare professionals must be present on site of the patient all the time and
secondly, the patients remains admitted in a hospital, bedside biomedical instruments,
for a period of time. In order to solve some of these problems, the patients are given
knowledge and information about disease diagnosis and prevention, a reliable and
readily available patient monitoring system (PMS) is required.

3. • What if a person goes out on some work and there is a stroke ?

4. • Let us take an example ,there is a person who likes to go out and enjoy his
only company like without anyone. Then he got to know that he is about to
have a stroke and there is no one around and he is not even in a case to
inform someone whom he knows. Then what are the cases possible?

5. Analysis of heart patients

6. RESULTS:
• One of the possible solution is that sending messages to the persons whom
he want to inform.
• Yeah he will get to know and can he go further ?

7. • Even after knowing this information he cannot go further because he will not
be able to where he is.
• So that message should contain the information like current location of where
the person is, then he can go save the person or can admit in the hospital
and further treatment can be taken.

8. • A system should be designed in such a way that when a person places his
finger on the pulse sensor and if it crosses the threshold value then a
message should be sent to the registered mobile numbers which contains the
current location of the person along with the recorded heart rate in terms of
BPM.

9. • This can be designed as a small device which can be a wearable and
remotely monitered.
• Can be implemented in smart watches and even in health industry.
• Further this can be extended by adding some sensors like temperature

10. REFERENCES:
• [1] Sung Woo Kim, Soo Beom Choi, Yong-Jun An, Byung-Hyun Kim, Heart Rate Detection
during Sleep Using a Flexible RF Resonator and Injection-Locked PLL Sensor, This article
has been accepted for publication in a future issue of this journal, but has not been fully
edited. Content may change prior to final publication. Citation information: DOI
10.1109/TBME.2015.2439681, IEEE Transactions on Biomedical Engineering TBME-01578-
2014.R2.
• [2] Antonio J. Jara, Wearable Internet, powering personal devices with the Internet of Things
capabilities, 2014 International Conference on Identification, Information and Knowledge in
the Internet of Things.
• [3] Bharavi U, Sukesh Rao M, Design and Development of GSM and GPS Tracking Module,
2017 2nd IEEE International Conference On Recent Trends in Electronics Information &
Communication Technology (RTEICT), May 19-20, 2017, India.
• [4] Lamia CHAARI FOURATI, Wireless Body Area Network and Healthcare Monitoring
System, 2014 IEEE International Conference on Healthcare Informatics