Cascade Canada Ltd. offers customized snow plow attachments designed to clear snow from various surfaces like parking lots and driveways. These snow plows come in different widths, heights, and mounting options, allowing for manual or hydraulic angle adjustments and are tailored to customer specifications. Various features include adjustable blade angles, multiple mounting class options, and a spring-loaded design for durability on uneven surfaces.

1. SPECIAL APPLICATION PRODUCTS
Snow Plow
_______________________________________________________
Cascade Canada Ltd. January 2013
5570 Timberlea Blvd., Mississauga, Ontario
Tel. 905-629-7777 Toll Free 1-800-380-2272 Fax. 905-629-7785
The Snow Plow or Blade attachment is used to clear snow from level ground such as parking lots or
driveways. They are available in various widths, heights and mounting combinations. They are
generally custom designed to fit a specific application. The blade size, mounting angles, need to
be determined by customer requirements. They can be offered with various features as described
below. Detailed information is required to determine the features for each application.
1. Truck mounting type? ITA hook carriage or Slip On Fork Pocket design.
2. Truck capacity, carriage width, fork size and spacing?
3. Mechanical or hydraulic blade angle?
4. Blade width.
5. Where is the plow to be used? Snow clearing or other?
Unit shown with ITA class IV mounting, 90 inches wide blade, manual angle selection.

2. SPECIAL APPLICATION PRODUCTS
Snow Plow
_______________________________________________________
Cascade Canada Ltd. January 2013
5570 Timberlea Blvd., Mississauga, Ontario
Tel. 905-629-7777 Toll Free 1-800-380-2272 Fax. 905-629-7785
FEATURES:
 The blade angle can be adjust manually by “Quick Disconnect” type pins or hydraulically by
activating a cylinder attached to blade.
 Blade angle 30 degrees to each side. Manual type at zero, 15 and 30 degrees each side.
 Blade widths available from 48 inches to 96 inches wide.
 The blade height is typically 18 inches.
 Available in ITA Class II, III or IV mounting. Combination II/III or III/IV also available.
 ITA class “Quick-Disconnect” bottom hooks available.
 It is important to advise the truck carriage width and/or fork spacing to determine the
mounting width and fork pocket spacing.
 Fork pockets can be secured to forks by pin through forks or chains.
 Replaceable bottom wear strip.
 Spring loaded design to prevent damage from curbs or rough and uneven surfaces.
 Heavy duty frame design with low center of gravity provides better traction.
Slip on fork pocket design with
manual locking angle selection.
Slip on fork pocket design with
hydraulic angle selection.