Hydra Bio Sludge Buster contains a powerful blend of aerobes and enzymes for better sewage treatment. The product is ideal for animal farms to treat sewage, sludge and liquefy compacted feed. More details: http://grease-eater.co.uk/sludge-and-sewage-treatment.html

1. Reduces harmful gases (ammonium levels)
Suppression of crusts in the pits
Breaks down and recovers organic material (accelerates the natural process)
Easy emptying of the pits for easy application on crops
Organic waste is made up of proteins, carbohydrates, fatty materials and fibres, which solidify making it
difficult to liquefy and reduce them. These insoluble solids and suspensions are particularly difficult to
break down. As a result, the solid build up and cake must be liquefied outside the bacterial cells and
through the action of enzymes segregated by special bacteria.
Aerobic and Anaerobic Bacteria
Bio Sludge Buster is a mixture of aerobic and anaerobic bacteria necessary for the molecular metabolism
of the organic waste. It works as a biological activator that breaks down the residual organic matter by
enzymatic means. In essence, a biological chain reaction begins that can continue until all the organic
material has disappeared.
Powerful Formula
Bio Sludge Buster contains materials that increase the activity of the enzymes, such as salts, humectants,
energetic products that catalyse and accelerate decomposition reactions and humidifiers to increase the
contact between enzymes and the waste materials. The formula of complies with the principle of waste
retention until the bacteria can digest the solid materials. In this way, only the materials made soluble can
flow from the pit or be easily absorbed.
Dilution Rate
1 kilo Bio Sludge Buster per 50 m³ of slurry. This dose is recommended as a first load, repeat dosing to be
applied every 25 days. The doses are by way of guidelines, as in each case it is necessary to consider the
characteristics of each pit or drain, as well as the volumes.
Directions for Use:
Dissolve Bio Sludge Buster in warm water not exceeding 40ºC in a drum and leave to rest for 20 minutes,
30 at most. For large storage systems stir and add as much water as possible to dilute and spread or mix
over the tank surfaces. Temperature enhances the action of Bio Sludge Buster provided it does not exceed
40 ºC. The lower the temperature, the lower the speed with which the waste is broken down.
Bio Sludge Buster
Bacteria / Enzyme Treatment - Farm Wastes
Liquefies Farm Sewerage & Compacted Feed
Hydra International Limited
Cerberian House, Carters Lane,
Kiln Farm, Milton Keynes MK11 3ER, U.K.
Tel: 01908-265889 Fax: 01908-262097
Email: sales@hydra-in.com Web Site: www.hydra-int.com
Accelerates Breakdown of Organic Material
Clears Blockages & Prevents Blinding Screens
Considerably Reduces Bad Odours & Flies

2. Material Safety Data Sheet
All the information on this sheet relates to the concentrated product only, in use dilution will decrease any possible hazard significantly.
Manufacturer
Hydra International Ltd
Milton Keynes MK11 3ER UK
Tel: 01908-265889 Fax: 01908-262097
E-mail: sales@hydra-int.com Web Site: www.hydra-int.com
1. IDENTIFICATION Bio Sludge Buster
2. COMPOSITION A powder blend of Bacillus sp and Pseudomonas sp, Cellulase / Protease / Amylase / Lipase, Activators
and Surfactants.
3. HAZARDS IDENTIFICATION Persons with known respiratory disorders (eg asthma) should avoid inhalation of the powder.
The product contains enzymes so there is a risk of sensitisation reactions in certain susceptible individuals
4. FIRST AID MEASURES EYES Flush with copious amounts of water
SKIN Wash with soap and water
INHALATION In the event of excessive inhalation, remove to fresh air and obtain medical advice.
Non-toxic, but if in doubt seek medical advice
INGESTION In the unlikely event of ingestion seek medical aid immediately
Give nothing by mouth to an unconscious person
In all cases, if symptoms persist, seek immediate medical advice
5. FIRE HAZARD &
FIRE FIGHTING PROCEDURES
Any extinguishing media may be used but should be appropriate to the cause of the fire. Low degree of
risk due to thermal decomposition
6. ACCIDENTAL RELEASE
MEASURES
In the event of accidental spillage, sweep up and wash away remainder with plenty of water
7. HANDLING AND STORAGE Store product in a cold dry place.
Prolonged storage in fridge or deep freeze.
Protect from light, raised temperature and humidity.
8. EXPOSURE CONTROLS AND
PERSONAL PROTECTION
RESPIRATORY PROTECTION Wear respiratory protection to avoid breathing in dust
VENTILATION Not applicable
PROTECTIVE GLOVES Wear PVC or Rubber Gloves as appropriate
EYE PROTECTION Wear goggles if task or application method could result in
eye contact from accidental splash or spray
OCCUPATIONAL EXPOSURE LIMIT Not applicable
9. PHYSICAL AND CHEMICAL
PROPERTIES
PHYSICAL STATE Powder
COLOUR Pale Tan
ODOUR Slight
FLASHPOINT Non Flammable
SOLUBILITY Water Soluble
DENSITY 51g/100 cm3
SOLUBILITY IN WATER 100 gm/100 ml (at 25°C)
pH VALUE 4.5-5.5 (10 gm/100 ml at 20°C)
10. STABILITY & REACTIVITY DATA CHEMICAL REACTIVITY Not applicable
STORAGE STABILITY The stability of the bacteria is dependent upon the storage
conditions, see Sec.7.
All other constituents are stable under normal storage conditions.
HAZARDOUS DECOMPOSITION
AND COMBUSTION PRODUCTS Not applicable
11. TOXICOLOGICAL INFORMATION EYES Irritant
SKIN Irritant
INHALATION May cause irritation to mouth, throat and digestive tract
INGESTION May cause irritation to mouth, throat and digestive tract
No toxic effect on the rat (2000 mg/kg)
Limit test for acute oral toxicity (Annex V, EEC Commission Directive)
12. ECOLOGICAL INFORMATION Naturally occurring saprophytic, non hazardous bacteria on readily biodegradable base
13. DISPOSAL CONSIDERATION Flush away with water
14. TRANSPORTATION INFORMATION Not dangerous for transport
15. REGULATORY INFORMATION
RISK PHRASES
SAFETY PHRASES
HAZARD SYMBOL
LABELLING INFORMATION
None
None
None
16. OTHER INFORMATION 1st Sept 2008
The information contained in this document is provided in accordance with the requirements of Chemicals (Hazard Information & Packing) Regulations. The product should not be
used for any purpose other than as stated on the label without obtaining specific written instructions directly from the supplier’s Head Office. As specific conditions of use are outside
the supplier’s control the user is responsible for ensuring the requirements of relevant legislation are complied with. The user assumes all liability for damage or injury caused from
abnormal use, failure to follow recommended practices & any hazard inherent in the nature of the product.