Installation instrutions for installing Rieger tuning illuminated shift knob for VW, Audi, BMW and Mercedes-Benz.

1. Rieger Illuminated Shift Knob Installation Instructions www.riegeretc.com

2. Start by removing the red ash tray bin. Unscrew the torque head screw at the bottom of the ash tray assembly. Flip over the ash tray assembly, cut the wire tie and unplug the power source assembly. www.riegeretc.com

3. Next, lift up the shift boot. To do this, you will need to remove the plastic ring that the skirt is fitted around. Fro m the rear of the skirt (ring) push forward and the piece should come out, allowing you to lift up the boot. Find the brass ring under the knob assembly and remove it. Tin snips work well for this. Pull the OEM knob straight up to remove it from the post. www.riegeretc.com

4. Next, you can either use connectors to attach the wires, or Simply use electrical tape. www.riegeretc.com

5. Put the new shift knob on the post. Run the wires over the foam towards the power source. www.riegeretc.com

6. Connect the red wire to the blue wire and the brown wire to the brown wire of the power source of the ash tray light. (see picture below) It is recommended turning on the lights now to test your connections. The shift knob lights should only come on when the car's lights are turned on and should work with the dimmer. www.riegeretc.com

7. With the boot above the knob, tighten the (3) alan head screws around the base of the knob. Use the provided alan head wrench that came with the knob. Reassemble the ash tray and boot assembly. www.riegeretc.com

8. Enjoy your new Rieger illuminated shift knob! www.riegeretc.com

9. www.riegeretc.com