The ignition system helps to start your car. Electrical issues leads to failure of the ignition system. Issues in the steering wheel binding can cause the ignition system to fail. A worn ignition cylinder does not allow the car to start. The below-mentioned slideshow tells about the problems associated with ignition system of a car.

1. Problems Associated with Ignition System of a Car

2. The ignition system is the main
source for starting the engine
of a car.

3. Ignition switch problems can
cause unexpected shutdowns
or electrical problems.

4. You must be aware of the
mechanical and electrical
reasons for ignition problems.

5. Steering wheel
binding

6. The ignition cylinder is
mechanically connected to
the steering wheel lock.

7. It prevents the driver from
steering the car without the key.

8. Sometimes, you turn off the
engine with the steering wheel
turned or turn the steering wheel
after turning off the engine.

9. The steering wheel lock can
bind and prevent you from
turning the ignition.

10. Worn ignition cylinder

11. Over time, the mechanical keys
and key cylinders used in your
car's ignition system tend to
wear out.

12. Also, the heavy keychain can add
more stress to the ignition
cylinder, increasing wear.

13. After a while, the key may fall out
of the cylinder or be unable to
turn out of the lock position.

14. An unworn key may not turn a worn
ignition cylinder, as they haven't
worn in the same pattern.

15. Ignition switch fault

16. The car’s ignition switch is
connected to the ignition
cylinder by a shaft or lever.

17. Inside the ignition switch, several
contacts connect vital electrical
systems needed to start and run
the car.

18. Worn ignition switch contacts,
temperature problems, or broken
springs can all cause the ignition
switch to fail.

19. Also, poor ignition switch
contacts could shut the engine
off while driving, which could
be dangerous.

20. Immobilizer problems

21. Modern cars with immobilizers
use transponder keys to enable
or disable engine starting or
running.

22. The chip in the key transmits a
specific code, & if this code
matches the ones programmed
into the car, engine starting is
enabled.

23. An incorrect key code, such
as from an unprogrammed
key or damaged key, would
prevent engine starting.

24. A broken immobilizer
antenna wiring can prevent
the engine immobilizer from
reading transponder codes.

25. Visit Us
https://www.loudenmotorcars.com/