1. The document contains a collection of questions and answers related to software testing. 2. The questions cover topics like test objectives, test process activities, test design independence, and definitions of common software testing terms. 3. The answers provide explanations for selecting the correct response and identifying mistakes in the incorrect response options.

1. KUMPULAN SOAL
BESERTA PENJELASAN
JAWABAN
Graham et.al (2011)
IKHWANA LUTFI
PRODI SISTEM INFORMASI
FAKULTAS SAINS & TEKNOLOGI
UIN SUSKA RIAU
Present By

2. a. Gaining confidence
b. Finding defects
c. Preventing defects
d. Providing information for decision
making
1
When test cases are designed early in
the lifecycle, verifying the test basis
via the test design, which common
test objective is being achieved?

3. Answers C
The other three are achieved primarily by doing
dynamic testing. This is a tricky one because you are
very likely to find defects while doing this analysis
and this may lead to either gaining or destroying
confidence and needing to supply information to the
decision makers. However, the wording of the
question matches the wording in the syllabus that
defines preventing defects.

4. a. During the planning activities
b. During the implementation and
execution activities
c. During the monitoring activities
d. During all the activities
2
When following the fundamental test
process, when should the test control
activity take place?

5. Answers D
Control occurs throughout the project to ensure that
it is staying on track based on the plan and to take
any corrective steps that may be necessary.
The monitoring information is used to determine if
control actions are needed.

6. a. Test planning
b. Test analysis aand design
c. Test implementation and execution
d. Evaluating exit criteria
3
Designing and prioritizing high level
test cases occurs during which
activity in the fundamental test
process?

7. Answers B
The design and prioritization of the high level test
cases happens during test analysis and design.
Prioritization of the test procedures happens during
implementation and execution.

8. a. Tests are designed by the person who
wrote the code
b. Tests are designed by a developer other
than the one who wrote the code
c. Tests are designed by an independent
test team
d. Tests are designed by an outsourced
test team
4
Which of the following is the lowest
level of independence?

9. Answers A
When the person who wrote the code is the person
designing the tests, that is the lowest level of
independence possible. The higher levels of
independence come from separating the test design
from the development of the code.

10. a. A developer makes a mistake which causes a defect
that may be seen as
a failure during dynamic testing
b. A developer makes an error which results in a failure
that may be seen as
a fault when the software is executed
c. A developer has a failure which results in a defect that
may be seen as a
mistake during dynamic testing
d. A developer makes a mistake which causes a bug that
may be seen as a
defect when the software is executed
4
Which of the following is a correct
statement?

11. Answers A
The developer makes a mistake/error which causes
a defect/fault/bug which may cause a failure when
the code is dynamically tested or executed. B is
incorrect because fault and failure are reversed. C is
incorrect because failure and mistake are reversed.
D is incorrect because it’s a failure that’s seen during
execution, not the defect itself. The failure is a
symptom of the defect.

12. IKHWANA LUTFI
PRODI SISTEM INFORMASI
FAKULTAS SAINS & TEKNOLOGI
UIN SUSKA RIAU
Present By
Lanjutan Soal di Part 2