Just to give you all an insight into the software, i have identified below what it is capable of.............. • NDT inspection registers for Eddy Current Inspection, Ultrasonic Inspection & Magnetic Particle Inspection • Derrick inspection in accordance with API RP 4G • Crane inspections in accordance with BS 7121 pt 2 & API RP 2D which is linked to the MPI report via serial number, this lets you see at a glance that the crane has been MPI’d • Winch inspections in accordance with ASME B30.7 which is linked to the MPI report via serial number, this lets you see at a glance that the winch has been MPI’d • Test Reports & Registers in accordance with LOLER & international standards which is linked to the MPI and EC report via serial number this lets you see at a glance that the item has been MPI’d/ECI • Visual reports & registers which is linked to the MPI and or EC report via serial number this lets you see at a glance that the item has been MPI’d/ECI • Under Crown sheave inspection • Quarantined Equipment register which is linked to the Corrective Action register via serial number this lets you see at a glance that there has been a corrective action raised for that item • Rejected Equipment register which is linked to the Corrective Action register via serial number this lets you see at a glance that there has been a corrective action raised for that item • Corrective Action Register with photographic evidence • Forklift Inspection Report which is linked to the MPI report via serial number this lets you see at a glance that the item has been MPI’d • Statement of fact for all safety gear (Harnesses/ lanyards etc) • Drill handling tool wear charts which are linked to the MPI report via serial number, this lets you see at a glance that the item has been MPI’d • Elevator link wear chart which is linked to the MPI report via serial number, this lets you see at a glance that the item has been MPI’d • Calibration certificates for MPI yoke, EC set, UT set can also be inserted into the software All reports are produced in the background saving time. Scanned certificates or photographs can be inserted into the Visual & Test register for traceability The results of all NDT carried out is also shown on each report The software is standalone at the present time and can be installed on any computer/laptop running windows 7 onwards also, by downloading the filemaker go app it can be used on both iPad & iPhone. I have also written Dropped Objects Software.