Download to read offline
Uploaded byMarcio Miranda
Logo system manual_en-us_en-us
This document provides information about analog outputs and inputs for the LOGO! AM2 AQ module. It can accept either 0-10V or 0/4-20mA signals, with different resistor requirements for each. The document also describes how to configure message text lines in LOGO! to tick or scroll either character by character or line by line.
Logo system manual_en-us_en-us
- 14. LOGO! AM 2AQ (0 ... 10 V DC)
- 15. LOGO! AM2 AQ(0 ... 10 V DC or 0/4 ... 20 mA)
- 16.
- 17.
- 20.
- 46. R1 0 ... 10V V1, V2: 0 ... 10 V DC R1: >= 5 kΩ I1, I2: 0/4 ... 20 mA R2: <= 250 Ω 0 ... 10 V R1 R2 0 ... 10 V 0/4 ... 20mA R1 V1, V2: 0 ...10V DC R1: >= 5 kΩ
- 103. AQ1 AQ2 M1 I1V2+ 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 21 2 1 2 Analog outputsAnalog inputsOutputs Inputs
- 154. MN OT 30h 30h 30h30h 20h100h MI 0 20 40 60 80 100 120
- 182. LOGO! functions 4.4 Specialfunctions list - SF LOGO! 182 Manual, 11/2008, A5E01248535-02 Message Ticking You can configure message text lines to tick or not tick. Two types of message ticking exist: ● Character by character ● Line by line Messages that tick character by character scroll off the characters of the message line one character at a time to the left with the additional characters scrolling in one at a time from the right. The time interval for the tick is specified by the TickTime message text setting. Messages that tick line by line by line scroll one half of the message off the display to the left with the second half of the message scrolling in from the right. The time interval for the tick is ten times the TickTime parameter. The two halves of the message simply alternate on the LOGO! Display or LOGO! TD. Example: Tick Message Character by Character The following illustration shows a one-line, 24-character message text: If you set this message to tick "character by character" with a tick interval of 0.1 seconds, then the initial appearance of this message line on the LOGO! Display or LOGO! TD is as shown in this illustration: After 0.1 second, one character of the message line ticks. The message appears as follows on the LOGO! Display or LOGO! TD: