How to Make Magma Sparkle Earrings Materials: Earwire Seven 4mm Jump Rings 3 Inch Piece of 20 Gauge Wire 10 Headpins 10 Beads of Choice Wire Cutters Round Nose Pliers 2 Chain Nose Pliers Step 1: Fold your wire in half using your hands. Then, use your round nose pliers and bend the wires across eachother to make a loop. Then, bend them back down so they meet. Use your wire cutters to trim the wire if they are not even. Step 2: Use your round nose pliers to make a loop on both sides of your wire. Step 3: Open up one of your jump rings and attach two more jump rings to it. Then close your jump ring up. This will make the chain. Step 4: Open up another jump ring and attach it to another one. Then attach both of these jump rings to the tree rings that you have already made. Step 5: Attach your last two rings to your newly made chain using the same technique. Step 6: You are going to insert all of your beads onto headpins and trim them at 3/8th's of an inch. Then make a loop at the end with your round nose pliers. These are your dangles. Step 7: Open both bottoms of your base and connect your chain from one side of the bottom to the other. Step 8: Open the jump ring on your dangles and attach one dangle to each link on your chain. Repeat this step until all of your dangles are attached to your chain.