The document provides instructions for making a bell in 6 steps: screwing screws into female parts and adding a saw, gluing cable connectors between the females, ensuring the connector is securely glued, screwing a large screw into the female, threading copper wire through two holes of the connector, and finishing by inserting the wire into the middle hole of the connector.

1. How can we make a
bell?
Adrià, Queralt & Amy

2. First step:
First we put the
screws in the
females and
between the
females we put a
saw

3. Second step:
Then we stick
with the glue the
connector of the
cables

4. Third step:
We make sure the connector it’s
stuck well

5. Fourth step:
We put the
big screw in
the female

6. Fifth step:
We put the
cooper wire
throw two of the
holes of the
connector

7. Final step
Our final step is
putting the wire in
the middle hole of
the connector

8. Finish !!
This is how it looks when you finish !!
