This document provides instructions for updating part files in the Agile system. It outlines searching for existing files by part number, with the goal of having both an Inventor part file and drawing for each part. It describes checking out existing parts from Agile, modifying and creating the required files, and checking them back in along with an ECO for release. It notes that over 250 single part models and drawings and more than a dozen assembly models and drawings were recently updated in this process.

2.  1) Find out what files exist in the Agile system by searching
part number.
 A) Sometimesa .DWG file onlyexists,an AutoCAD model
and drawing is all but most of the time an InventorPart (.IPT)
and a .DWG areavailable.
 2) End goal of updating parts is to have an Inventor
Part(.IPT) and Inventor Drawing(.IDW) on current
template with proper GD&T.
 A) The part and/ordrawing need to be createdor updated.
 B) Existing partscan be checked out of Agile, modified if
neededand the drawing created usingproperGD&T.
 C) Once everything is complete,an ECO is madeand the
drawings/partsarechecked back into Agile.
 D) This will start the release of updatesinto production.

3.  Over 250 single part models and drawings were
complete and attached to ECO for release.
 More than a dozen assembles with multiple
subcomponent parts and drawings were updated.

4.  Only AutoCAD model and drawing existed

5.  Using some trigonometry the compound angle model
was created in Inventor.