Rekha Agarkar Escorts Service Kollam ❣️ 7014168258 ❣️ High Cost Unlimited Har...
EQUIPMENT FOR RESEARCH WORKS AT DICON RESEARCH &.pptx
1. EQUIPMENT FOR RESEARCH
WORKS AT DICON RESEARCH
& DEVELOPMENT CENTRE
Contact: 08036246779, 08077712645
DEFENCE INDUSTRIES CORPORATION OF NIGERIA
(RESEARCH AND DEVELOPMENT CENTRE)
2. Atomic Absorption
Spectrophotometer (AAS)
For the detection of metallic elements in liquid samples through
the application of characteristic wavelengths of electromagnetic
radiation
Used in the analysis of compounds in solution: Employed in
Food and beverages
Water
Clinical and Pharmaceutical analysis
Mining operation-To determine the
percentage of precious metal in rocks
Uses light of characteristic wavelength.
The specific element can be detected, and
their concentration measured.
1
8. Torque Tester
A torque transducer which
converts torque measurements
into physical variables or
electrical signals that can be
measured and standardized.
7
9. Friction, Tear & Peel Tester
(FTP)
For measurement of the strength
of packaging materials, welded
joins, creases, folds and
perforation lines
8
17. Four ball Tribometer
For the determination of the
load-bearing capacity, wear rate
and extreme pressure of engine
oil and other lubricants through
computer aided simulation
16
18. Potentiostat / Galvanostat
Corrosion Analyzer
Uses
Corrosion monitoring
Evaluation of metals
Coating
Batteries
General electrochemistry
Weight loss in materials
APPLICATIONS
Oil rigs Water/ oil seals
Water/ oil seals
Dockyards/ shipyards
Aircrafts
Military hardware
17
19. Thermogravimetric Analyzer
Thermal Stability of materials
Oxidative stability of material
Composition of multi component system
Estimate life time of a product
Decomposition kinetic of materials
The effect of reactive/ corrosive
atmosphere of materials
Moisture and volatile content of materials
18
20. Dynamic Mechanical Analyzing
Machine
The dynamic mechanical
analyzing machine (DMA) is an
indispensable tool for
determining the visco-elastic
properties of mainly polymer
materials.
19
21. Metallographic Specimen
Automatic
Grinding and Polishing Machine
For grinding and polishing
metals and other engineering
materials
Grinding is done to remove saw
marks, levels and clean the
specimen surface. Polishing
removes the artifacts of
grinding.
20
23. Spectromaxx
Used to determine the chemical
composition of ferrous and
nonferrous metal including alloy.
APPLICATIONS
Auto industrial parts
General machinery
Foundry material
Air plane manufacturing
Petrochemical industries
Communication electronics
Military Hardware
22
24. Automatic Hot Mounting Press
Used to protected fragile or coated materials during
preparations and to obtain perfect edge retention
Also to enable safer and more convenience handling
of small, sharp, irregular specimen
APPLICATION
Specimen is embedded in resins (Bakelite)
Temperature range is set at 5minute or less
Bakelite’s cakes with metals samples embedded
Water is used as coolant to keep temperature low
23
25. Metallurgical Furnace (MUFFLE)
HEAT TREATMENT OF METALS
It is used in situations in which materials to be test treated is isolated
from the fuel and all the product of combustion (gases and ashes)
Temperature ranges from 0 – 1200°C
Used for high temperature applications such as glass, ceramics soldering
and brazing.
Uses electric heating elements.
The furnace is lagged with calcium carbonate
APPLICATIONS
Used for the heat treatment of different materials for structural
modifications to suit research and engineering applications
Aerospace industries; for testing flame retaining capacity of distinct
materials at high temperature which are to be equipped in aircraft.
24
26. DTQ – 5 Mini Precision Machine
Cutting
For cutting metal samples with
irregular shapes, before they are
mounted, getting them ready for
polishing.
25