Notes related to task of control yoke reconnection

1. Control Yoke Reconnection
of
EMBRAER 170
Eng.Ramez Enwesri (B1)
Libya – Petro Air Co.

2. The Task
 Task 27-11-12-840-801-A gives all steps and
procedure to carry out the Control Yoke Disconnect
Device – Reconnection.
 In this presentation we will focus on some points which
might be help, where we carried out this task few days
ago.
 But you have to obey the task.
Eng.Ramez Enwesri (B1) - Libya

3. The Practices Note
 You do not need to remove any parts to reach the
Disconnect Device. The Area is clear to set the tools.
 It will be good to use a Multimeter with long terminal
leads, to be far enough to hear the sound, as result of
Close Circuit between pins A & B.
 You have to know that the Reconnect Wrench jaws
movement should be out of each other.
 When you hear the sound of the Multimeter, do not
stop. Wait for seconds, and turn the Reconnect
Wrench for more 2 or 3 turns. You will feel a strong
reaction, then stop.
Eng.Ramez Enwesri (B1) - Libya

4. Jaws movement
Floating Plate Movement
Eng.Ramez Enwesri (B1) - Libya

6. Ramez Ramadan Enwesri
Eng. B1
Libya – Petro Air Co.
Email: rrenwesri@engineer.com
Mobile: +218 91 324 6152