The document provides instructions for drawing the general layout of a portal frame structure covering an area that is 42m long and 24m wide, with a clear height of 10m. It specifies that the required drawings are a plan view, side view, elevation, and end gable view, as well as all necessary views with the addition of a mezzanine floor. It notes that the shape of the rafter cross section depends on the bending moment diagram of the frame and can use a tapered non-prismatic section. The task is to draw the general layout according to the given dimensional data.

1. 1- General Layout (Portal Frame).
• Covering the shown Area (L*B) Using Steel Frame.
• It’s required to draw: Plan – S.v – Elev – End gable.
• By adding mezz-floor draw all necessary views.
Knowing that B=24m , L=42m with clear height= 10m
Eng/Mostafa_Saleh_Notes_2019/2020

2. • Plan • S.V
Eng/Mostafa_Saleh_Notes_2019/2020

3. • Main System
• End-Gable
Eng/Mostafa_Saleh_Notes_2019/2020

4. • Elev & Plane of mezz floor
Eng/Mostafa_Saleh_Notes_2019/2020

5. Note:- the shape of the cross section of the Rafter
Depend on the B.M.D of the frame
Eng/Mostafa_Saleh_Notes_2019/2020

6. Or Using Taper Section (non Prismatic)
Eng/Mostafa_Saleh_Notes_2019/2020

7. Task : Draw General Layout according to ID
data at the sheet.
• Thank you …
Eng/Mostafa_Saleh_Notes_2019/2020