1. Calibration Order Scenario: PM – QM Integration
Calibration Equipment

2. Generaltask List (IA06)

3. QM Data –Inspection points setup in theHeader as shown above

4. MIC assigned for the Operation as displayed.
Now create aMaintenance plan – For the Calibration Equipment (IP01)

5. Assign theGeneral task list for the Plan (We canalso Equipment task lists as well)

6. Scheduling overview: (IP24)
Now lets simulate Calibration orders for future dates for running IP30.

7. As I ran the simulation for 400 days – I had got the above order generated.
Lets view the scheduling overview…IP24

8. See orders generatedtill March 2018.
Lets releasethe order and do next steps.
IW32

9. Order is in createdstatus and I see no inspection lot generated.
Releasethe order now..
Save.

10. Open theorder again. An inspection lot should be generated. (PM-QMIntegration)
Lets view the inspection lot…

11. Inspection lot got generatedfor the order against theEquipment.
Now We need to do Result Recording and Usage Decision against the Inspection lot.
PM – QM Integration:
There areways to do theRR & UD:
QE51N

12. Result Recording…
Enter your results against each MIC

15. We see the lot status as Results confirmed.
Now lets do the UD:

16. Click Save

17. Click OK
Prompts to Order confirmation screen.

18. Enter work hours and save.
Lets go theorder and see thestatus.

19. Order got CNF  Confirmed.
See the Inspection Lot status:

20. RR & UD has been made.

21. CASE II : NegativeScenario Test (when my results areout of limits)
Lets takeorder with inspection lot – 140000000356
Lets do RR & UD

23. I had recorded failure results here. As we see above

24. Am selecting – Reject – Out of Tolerance
No do the UD

27. Save the order.
If you wanna rework on theOrder – As wesee PCNF.
We can add an another step to install an new Equipment in our operation

30. Now you can TECO this order.
Note: (order would not be copiedto Inspectionlot as we the results have failed)