Share DIY - How to replace an iphone 7 screen

1. DIY - How to Replace an iPhone 7 Screen
The iPhone 7 Plus's screen is vulnerable, such as dropped, smashed,
or otherwise chipped against surfaces, so much as you completely
smash your screen, you're probably in need of a screen repair.
When you crack your screen, maybe you will encounter some
difficulties about detail, such as it also destroys your iPhone's
water resistance. If your iPhone 7 Plus screen is broken, you want
to replace the screen by yourself. This article will help you.
Repair Process:
1. Put off the iPhone 7 Plus.
2. Using a TS1 (0.8mm) screwdriver to remove the two screws, at

2. the bottom of the phone locate.
3. Above the Home button, put a suction cup directly on the
display and gently try to remove from the rear casing.
4. If necessary, use a wedging device to carefully break the seal of
the adhesive and pry the display from the rear casing.
5. Open the iPhone 7 display and remove the four screws to free the
display plate. Then use tweezers to lift the display plate away.
6. Use the spudger tool to pull of the three LCD connecting cable
strips.
7. Unscrew two more tri-point screws at the top, right-hand corner
that hold down your proximity sensor.
8. Remove the plate over the proximity sensor reveal one more
cable strip that, when disconnected, will free the front display from
the back of the phone.

3. 9. Remove the three Phillips-head screws from the bracket behind
the ear speaker at the top of the display side.
10. Pulling away The bracket to reveal the iPhone’s camera.
11. Pull back the camera to remove the two screws holding in the
ear speaker assembly, and lift out the ear speaker.
12. Gently wiggle and pull up on the proximity sensor to remove it.
Find the touch ID assembly, at the bottom of the display side.
13. Unscrew the four tri-point screws holding down the bracket,

4. and remove bracket.
14. Gently wiggle to remove touch ID, then remove the LCD
back-plate by unscrewing six, tri-point screws.
15. Using the spudger tool, lift up the LCD back-plate to reveal the
cable strip connected to back-plate.
16. When you free the LCD back-plate of the cable, it will
disconnect easily.
17. Discard your old, damaged LCD and replace with the new
screen, folding down your cables and lining up the side mounts, to
put the 6 screws back into place.
18. Continue to follow the steps in reverse to reassemble the phone.
More information about phone repair guide and tools, you can
choose Vip Fix Shop Team.