Procedures to install a TOTR13ST Mounting Bracket, Shad SH50 Top Box, DOB50KL Light Kit, and a LED-SH50TTS Light Kit on a 2015 Triumph Trophy SE ABS motorcycle. This is a work in progress. The presentation show how to access the rear light's wiring so far. The installation of the mounting bracket, top box, and light kits will be added as they become available

1. Remove the three bolts indicated using a 5 mm Allen wrench

2. Remove these four bolts ith a 13 mm wrench
This is a Torx T30 screw that releases the seat
locking mechanism so the grab bars can be removed
Remove the four bolts indicated using a 13 mm socket or open-end wrench.
Note: The two forward bolts are no the same length as the rear bolts.
Remove the screw indicated using a T-30 Torx wrench.
Lift out the grab bar assembly.

3. Bike Side of taillight connector
Taillight side of taillight connector
The wiring rear lights wiring harness should be visible now.

4. Attach pigtail leads for a 5 or 6-pin connector.
Route the cables from the opposite side of the connector
to the rear light kit(s) being added.