A specification checklist to ensure you have all the parts when using the Traxx product by Kimball.

1. Traxx Checklist
This list is provided for your convenience. It does not replace an actual specification check with the pricelist. It is essential to
consult the actual pricelist for the specification tips located on the items listed within your bill of materials.
General Overview
 Review Specification tips on product throughout pricelist.
 Confirm “special” quote pricing including product model number with description and option codes.
 Finishes (Any upcharges? 10%-20% for various finishes), (Wood) 547 (Paint) 550 (Laminate)
551 (thermafoil). Additional fixed charges may also be incurred based on development as a whole or based on individual
model numbers.
 Have COM fabrics been approved.
 Review panel run and load bearing restrictions, page.
 Service parts are listed as net in worksheet.
Plan View
 Does your Traxx length equal the footprint of the linear space used?
 Are you making several small cuts in the Traxx? Are additional splice plates required?
 Will you be cutting tiles? Will additional trim channels be necessary.
 The smallest load bearing run of Traxx can be no less than 24” and must attach to two studs.
 Fastener Concealment: felt or vinyl – vinyl is required when using presentation tools.
 Are single or full end trims required at the end of the Traxx run?
 When matching Traxx with Cetra is a trim cap needed?
 Correct type of tile is specified on the applied walls if it matching a specific Footprint series.
 Only the fabric tiles next to the marker board tile require additional trim channels.
 For exposed ends, was a full height end trim used for Interworks starter conditions exposed.
 Specify Presentation Tools and Work Tools as required.
Elevation View
 Designate the height at which the tiles will be hung in conjunction with chosen panel system.
 Review yardage requirements for COM selections.
 Remember to select a railroaded fabric application when used with Xsite.