1. CLEAN UPPER AND LOWER MUD PRESS SHOWERS
STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMS
REDUCE WATER FLOW TO LOWER MUD PRESS SHOWER BAR
Below the mud press water T junction is a red lever tap. Close the
tap off until the water is only trickling from the shower holes.
OPEN SHOWER BAR DRAIN TAP
Walk around to the back of the mud press with the bottle brush rod.
Fully open the shower bar release tap.
Do not stand
directly in line with the end of the
tap as water may quickly exit
shower bar, soaking you.
CLEAN INSIDE SHOWER BAR
Insert the bottle brush rod into the shower bar.
Move brush in and out of shower bar in an attempt to remove any
build up on the inside of the bar.
Again, do not
stand directly in line with the end
of the tap as water may quickly
exit shower bar, soaking you.

2. CLEAN UPPER AND LOWER MUD PRESS SHOWERS (cont.)
STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMS
ALLOW BUILD UP TO DRAIN
• Remove brush from inside the bar.
• Allow some time for the water to flush the build up out of the
inside of the bar.
CLOSE RELEASE TAP
• Once all build up has been washed out of the bar, fully close the
release tap.
• Double check that tap is closed correctly.
OPEN LOWER SHOWER BAR INLET WATER
Below the mud press water T junction is a red lever tap. Fully open
the tap to allow full pressure water to pass into the shower bar.

3. CLEAN UPPER AND LOWER MUD PRESS SHOWERS (cont)
STEPS / ACTIONS SAFETY & QUALITY PICTURES & DIAGRAMS
CLEAN UPPER SHOWER BAR
Follow the same procedure for lower shower.
Inlet tap is mounted to the right of the T junction.
Climb ladder and follow same procedures as for lower shower bar.
Do not stand
directly in line with the end of the
tap as water may quickly exit
shower bar, soaking you.