5. -Duct tape positive end of battery to negative
end of 2nd battery
-Cut 2 inches of wire off, strip both ends
leaving 6 inches of wire behind
-On long wire strip 1 end & separate 2 wires
1 inch down. Then strip other end
-Take LED Diode, positive end & attach small
wire
- Take negative end & attach long wire
6. -Put a wrap of duct tape up close to the bulb
Touch short wire to negative end of batteries
-Touch long wire to end of positive batteries
(light should come on)
-Fray copper wire out on short wire & tape to
negative end of batteries
-Tape wire down onto batteries @ top &
bottom, leaving 1 inch hanging down
-Cut paper to length of flashlight, housing in
the bulb
7. -Tape paper @ top, middle, bottom
-Trim hanging wire so as your thumb can
easily push it to the positive end of battery