The document describes a partial foil woven highlighting technique used on a client. Medium to coarse hair was pre-lightened to a level 6/10. Two shades of highlights (Magma /07 and /89) were woven through sections of the hair using foil, leaving gaps in between. The highlights were developed for 20-40 minutes then washed out. A nourishing spray and thermal protectant were used when blow drying and styling the hair straight. The finished result blended the highlights throughout the hair to achieve dimension and a subtle effect, fulfilling the vision discussed with the client.

2. Partial Colour
Partial Foil Woven

3. Partial Colour – Partial Foil Woven
Highlights / lowlights are colouring techniques which allow
sections of hair to be coloured while leaving the surrounding
hair untouched. The overall aim of the partial head method
is to create a uniform variation of several shades through a
designated area. There should be no 'gaps' or 'patches' in
the finished result, that is the hair can be combed in any
direction and the highlighted/lowlighted effect is visible.
For the presentation of the technique the following criteria
for model selection are:
− Hair Length minimum of 3" or 8cm on the
designated area
− Natural substrate 3/0 or lighter with <50% white hair
Target: →
Partial head highlight/lowlight application using a minimum
of two shades, with a bowl & brush resulting in an even root
to tip result and a 'visible' difference from the natural hair
colour.
❑ Correct assessment of the natural substrate.
❑ Client prepared appropriately.
❑ Self prepared appropriately.
❑ Correct mixing and measuring.
❑ Clean uniform sectioning and evenly woven sections.
❑ Application technique started at the lower section
of the designated area. Working up to the centre top
section finishing on the top of the head.
❑ Foil should appear neat with clean folds – no crumpling.
❑ Result a uniform root, middle lengths and ends,
uniformed colour variation throughout the designated
area with a clear distinction between the colour choices.
Definition Bronze
3

4. Texture
Porosity
Natural Colour
Percentage White Hair
Additional Comments
Partial Colour – Partial Foil Woven
Your Client Before photo
4
Medium to Coarse
My model Hemangi has done a 6/ (dark Blonde) color
from Koleston Perfect. Has beautiful long hair. Was
looking for few pieces of highlights that would blend
across her hair.
Average on length, Porosity found at ends
6/
0%

5. Please tell us about the vision you have for your client.
Partial Colour – Partial Foil Woven
Vision for Your Client Scan and insert your drawing
5
Hemangi has a long length with a long forward
graduation. My model has just finished her college and
bagged her first job too. She came in looking for
highlights but was sceptical on how the process would
be. Post my consultation/diagnosis, I recommended her
to shorten her length while refreshing her graduation. I
also recommended her with highlights of soft woven
pieces on the crown that would blend across her length.
Hemangi exactly understood my end vision on her hair
and agreed with the same.

6. What product and combination of products did you use?
Please describe the technique used.
Partial Colour – Partial Foil Woven
6
The Colour Application Insert Step by Step Photos
Sectioning Trolley Set Up
Application
Used Wella – ‘Herringbone Technique’. Took Sections
on the crown like a “V” part and cliped the section.
1st – Used Magma /07 with Welloxon Perfect 6% (20
Volume) Ratio – 1:1.5
2nd – Used Magma /89 with Welloxon Perfect 6% (20
Volume) Ratio – 1:1.5

7. Please describe any additional steps you took during
or post colour development.
Used Herringbone Technique from front to back on the
horse shoe. Applied Magma /07 and /89 on alternative
sections as weaves blocked in foils. Kept a visual check
on both foils between 20 – 40 mins. Post 30 mins,
Washed the color and applied Post Color Treatment.
Partial Colour – Partial Foil Woven
The Colour Development
7
Insert Step by Step Photos
Clean Towel Dried Hair

8. Care treatment – please describe the care products used and
why did you choose these products?
Describe the haircut.
Partial Colour – Partial Foil Woven
Colour Removal Hair Cut
8
For washing out the color, I used SP Color Save
Shampoo to give longer color intensity and brilliance.
Followed by Magma Color Complete to balance the pH-
value and to give long lasting color result. Kept it for 3
mins and then rinsed it out.
Hemangi and I agreed to reducing her length. For the
same, tok sections based on her parting to create a line
with a ‘U’ shape at the back. Connected the guide from
back to front. No layers or Graduation given here,

9. Please describe the products and techniques you used
in styling and finishing your total look.
used Enrich Nourishing Spray before the blow dry.
Used Wella Professionals – Thermal Image from the Dry
stage to protect hair from heat while ironing. For Blow
dry, used big wooden round brush to add shine and
movement, followed by ironing on thick sections.
Partial Colour – Partial Foil Woven
The Hair Styling & Finishing
9
Insert Step by Step Photos

10. Please describe how satisfied you are with the finished colour
and look.
The motive was to keep the hair long and no reduction
on length at the crown. The Technique done here gives
a natural effect on the hair. Using different tones gave a
dimensional effect on her hair whilst making it look rich
and subtle.
I achieved of what I had a vision at the start and my
model was very happy with the end result.
Partial Colour – Partial Foil Woven
Full Finished Result
10
Insert Finished Look Photos