1. The L + R Delay settings adjust the effects in each ear
hole, say if I was to adjust the Damp setting to a higher
frequency, and the L setting was higher than the right,
it would seem as if the effect was more effective on
the left side of the sound listening device.
The Damp setting adjusts the echo
effects, the Resonance effect just
applies a lot of disturbance noise that
builds up the more the echo effect is,
and the Low Cut effect reduces the
volume of the echo so the original
audio comes through more.
The last effects on this option menu
allow you to make the audio seem
more distant, which is applied using the
(IN) option. The Filter Enables and
Disables the effects, and I’m not really
sure exactly as to which aspects of the
audio is adjusted by the Midi and Swap
effects.
These 3 options apply the high pitched robotic effect that is heard in the
clip.The other options that surround the options that I adjusted are
practically the exact same thing in the form of not really doing much when
I turn them full up or down, and I didn’t really notice a change in the audio
effects after using the rest of the options.