This document contains specifications for various pieces of drilling and geophysical equipment including: - Drilling rigs with depths from 1000-3000 meters, hook loads from 600-1700 KN, and pump powers from 185-800 HP. - Geophysical survey systems with options for 1-4 data channels, internal storage up to 80GB, and laptop or workstation configurations. - A laser scanner with 2mm linearity up to 25 meters and 28 million pixels. - A 1200 ton crane barge with a 40mm towing wire and 65mm work wire each 700 meters long.

7. SPECIFICATION
Channel number: 120/500
RTK accuracy: horizontal 8mm+1ppm (RMS)
vertical: 15mm+1ppm (RMS)
Operating temperature: -40 degrees ~+65
SPECIFICATION
Flight time: 55 minutes
RTK accuracy: Level: 10mn+1.0ppm
Vertical: 15mm+1.0ppm
Take off mode: hand throw off

8. SPECIFICATION
Endurance time: 4 hours
Wind resistant capacity: 6
Load: 2kg
Landing: catapult / parachute
Flying height: 5000m
Cruising speed: 110km/h

9. SPECIFICATION SPECIFICATION

10. SPECIFICATION
SPECIFICATION

11. SPECIFICATION
Unicorn Compensation apparatus: AARC51
Caesium optically pumped magnetometer: CS - VL
Weight: 20 kg
Flying height; 4000 m or less
Wind resistance levels: level 6
Range: 15000-105000 nT
Sensitivity: 0.0006 nT/Hz
Absolute accuracy: < 2.5 nT (maximum range)
SPECIFICATION
Word count: the 3 track and 3 electric way; If the composition of network
acquisition system, the number is not restricted
TDEM measurement channels for 16-24
Current range:0.5-40A
Frequency range : 0.0039Hz-10,000Hz
Time control, GPS time synchronization accuracy of + / - 0.1 us

12. SPECIFICATION
Frequency range : 0.015625-8192Hz
Channel number:16
Input impedance: 10MΩ
dynamic range :212dB
Minimum detectable signal: ±0.03μV
Duty ratio :50%,100%
SPECIFICATION
Resolution:0.01nT
sensitivity : 0.05nT
Absolute accuracy : ±0.2nT

13. Ground Electromagnetic Penetration System
SPECIFICATION
Antenna: 16-80,100,200,400Mz,1.6 Gz
Scan rate: 2480 sweep/SEC; 4890 sweep/SEC
Dynamic range: 160 db
Working temperature: - 40 ℃ - + 55 ℃
SPECIFICATION
Voltage channel: ±6v ；Current channel: 5A
Measurement accuracy: Vp =≥10mr 0.5%±1 bytes, Vp < 10mr ±1%±1 bytes
Input impedance: >50M Ω
Apparent polarization range: ±1% ± 1 bytes
IP≥ 10mA±0.5%, ±1 bytes
IP<10mA, ± 1% ± 1 bytes
Power supply time: 1-60 seconds, duty cycle 1:1

14. SPECIFICATION
Electrode converter number: 60
Insulation impedance: ≥500MΩ
Maximum working voltage: 450VDC
Maximum working current: 2.5ADC
Power: eight D size batteries (or same specs nickel-cadmium battery)
Operating temperature: -10℃～50℃
Digital Acquisition System WZG48A
SPECIFICATION
Number of channels 6, 12, 24 and 48
Sampling rate: 10μs, 25μs, 50μs, 100μs, 200μs, 500μs, 1ms, 2ms, 5ms, 10ms and 20ms
Dynamic range 0 to 144 dB
A/D converter: 24 bits
Frequency range 0.1 – 5000 kHz Instrument noise less than 1μν
Phase shift ± 0.01ms
Working temperature -10℃～＋50℃ 90%RH
Power +12v
Record format: SEG-2
Hard-disk 40GB, high-resolution TFT and colour LCD screen

15. Shallow Engineering Seismograph SWS-6
SPECIFICATION
Number of channel: 24
Amplifier: instantaneous floating point amplifier
A/D conversion: 20+bit
Sampling number：512、1024、2048、4096、8192（For micro tremor
measure:4K~128K, with 6 steps）
Sampling rate：10µs~2ms (For micro tremor measure: 10、20ms)
Signal enhancement: 32bit
Frequency Response Range: 0.5~4000Hz
Digital filter： All Pass，HP1，and HP2
Computer Configuration: Industrial grade Control Computer ，
System: win-XPE
Display: 800x600 dot matrix, LVDS true color LCD
Storage: CF card
Interface: Dual USB interface
Power: DC 12V, battery-powered
Weight : 8kg
Size: 400x300x160mm (SWS-6)
Environmental: -5~50°C; 40~2°C，humidity 90~95%RH continuous reliable
working last 4 hours.

16. Geophysical Survey System SIR System 10
SPECIFICATION
Antennas: Compatible with all GSSI antennas
Number of Channels: Records data from 1 or 2 hardware channels simultaneously; 1 to 4
data channels, selectable
Data Storage: Internal memory: 80 GB Internal
Optional (External): Any standard PC peripheral using the PC parallel port, USB port or
PCMCIA port
Display: 13.3 inch color LCD Display on a Panasonic Toughbook Laptop
Display Modes: Lines can and O-scope, 3D
In lines can display, 256 color bins are used to represent the amplitude and polarity of the
signal

17. FARO Laser Scanner
SPECIFICATION
Linearity error: 2mm, 25m
High resolution: 28000000 pixels at a time.
Digital seismic instrument
SPECIFICATION
Digital to analog conversion: 24 bits
Dynamic range: 120dB
Sampling rate: 4, 2, 1, 0.5, 0.25ms
Operating temperature: -40 degrees to 70 degrees
Bandwidth: 0-250Hz
Distortion: -62db

18. Seismic data processing and interpretation workstation
SPECIFICATION
CPU:Intel Xeon E5 3.41866 8C CPU
Memory: 128GB DDR3-1866 (8x16GB) 2CPU RegRAM
Hard disk: 3TB RPM SATA built-in 2*600GB+2*3
Graphics card: Quadro K5000 4GB 1st GFX NVIDIA
Operating system: Linux
SPECIFICATION
CPU:64 bit Ultra SPARC- III, 1200MHz
Memory: 4096MB
Graphics card: Creator3D
Hard disk: built-in 73GB+300GB
Operating system: SunOs, Solaris

19. RIGS & PONTOON

20. DRILLING RIGS & SITE TEAM

21. DRILLING RIGS & SITE TEAM

22. Performance Unit Quantity Remarks
Drilling depth
（89mm Drill pipe）
m 2000
Rated Hook Load KN 720
Rated power of winch Kw 110
The Numbers of drilling pump
and Power
Kw 1×185
The inner diameter of Drilling
rig rotary table
mm 445
Drill floor height m 1.7 or 0
Available height of derrick m 27
Rotary table speed rpm 48，69，110，190
Rotary table maximum torque KN.m 18

23. Performance Unit Quantity Remarks
Drilling depth
（89mm Drill pipe）
m 2600
Rated Hook Load KN 1000
Rated power of winch Kw 154
The Numbers of drilling
pump and Power
Kw 1×350
The inner diameter of
Drilling rig rotary table
mm 445
Drill floor height m 1.7
Available height of derrick m 27
Rotary table speed rpm 45,65,103，178
Rotary table maximum
torque
KN.m 25

24. Performance Unit Quantity Remarks
Drilling depth
（114mm Drill pipe）
m 3000
Rated Hook Load KN 1700
Rated power of winch Kw 485
The Numbers of drilling
pump and Power
HP 2×800
The inner diameter of
Drilling rig rotary table
mm 445
Drill floor height m 4.5
Available height of derrick m 32
Useful capacity of solid
control system
m3 120

25. Performance Unit Quantity Remarks
Drilling depth
（89mm Drill pipe）
m 1000
Rated Hook Load KN 600
Rated power of winch Kw 567
The Numbers of drilling
pump and Power
Kw 1×185
The inner diameter of
Drilling rig rotary table
mm 711
The Numbers of Air
compressor
32.6m3/3.55MPa-
38m3/2.41MPa
Available height of derrick m 15.25
Rotary table speed rpm 48，69，110，190

26. HONGBANG 6 (1200TON CRANE BARGE)
SPECIFICATION
GENERAL ANCHOR & HANDLING EQUIPMENT
Ship-owner
Lianyingang Dali Underwater
Engineering Co,, Ltd.
Stern Roller (Dimensions) None
Address
Rm. 2203, East Tower of
International Trade Center,
No.10 Hailian Rd. Lianyungang,
Jiangsu Province, PRC.
Tugger Winches None
Chain Stopper Yes
Builder Lianyungang Longxiang Towing Wire 40mm x 50m x 2
Year of Built 2010 Spare Towing Wire 100mm x 200m
Type Crane Barge Work Wire 65 x 700m
Class Panama Spare Working Wire 65 x 700m
Flag Panama
Other Anchor Handling
Equipment
Pelican Hooks Shackles,
Classification and Society
Panama Stretchers etc.