REINFORCING OUR NATION’S INFRASTRUCTURE.

1. The Coating Solution Forum presents:
The Importance of Corrosion Prevention —
REINFORCING OUR NATION’S
INFRASTRUCTURE.
Presented by:

2. 02
TOPLINE FACTS
& FIGURES

3. How Stark is the Reality?
Estimated water main breaks per year:
240,000… roughly 27 per hour!1
1.5 million miles…
that’s how far all the water pipes
in America would run if lined up,
end to end!
03
Estimated loss to leaks/breaks daily:
6 billion gallons or 18% of total
national use.2
Of the almost 15,000 wastewater-treatment
facilities in the US, typical service life of plant
assets = 15 – 50 years.3

4. How Great is the Cost?
04
Estimated cost to repair &
replace the water/wastewater
infrastructure*
Up to $1 trillion4
*Over the first 20 years of the 21st century, excluding the cost for homeland security.
$1+ million6 Cost for one new water tower
(total # in the US over 1 million)
Over $1 trillion7
Cost to maintain our ever-
expanding water systems
(over the next 25 years)
$271 billion5
Estimated 5-year cost to
maintain & improve our water
infrastructure

5. How Attainable is a Qualified Solution?
Educating the
public and
industry
stakeholders…
Qualified
contractors and
certified workers.
The solution is
within reach
through…
05

6. 06
THE CORROSION
PROBLEM

7. What is Corrosion?
07
The physical properties of metal are
constantly in flux. This “disintegration
of metal” occurs through an
electrochemical process that starts on
the metal’s surface, as part of its natural
behavior.
As such, corrosion of steel rebar used to
reinforce concrete, causes cracking as the
byproduct of corrosion.

8. Causes of Corrosion
Water / moisture (humidity)
Acids
Bases
Salts
Oils
Within these water, potable, gray
water and containment systems,
the metallic form will continually
corrode due to a variety of factors:
8

9. 9
Assessment Selection and Engineering
While non-metallics and other
composite materials may mitigate
corrosion problems, costs can be
prohibitive and many are untested
for structural applications. If metals
are selected they must be protected.

10. Corrosion Prevention
Some of the common coatings used are: Ultra-High Solids
(Plural Component) Coatings, Poly Urea, High Performance
Acrylics, High Performance Alkyds, Alkyd Esters and Acrylics,
Epoxy Esters, Pre-Catalyzed Epoxies, Moisture Cured
Urethanes, VOC Compliant Coatings, Powder Coatings,
Metalizing, Vinyls, Radiation Cured Coatings, Sacrificial
Coatings, and Vulcanized Rubbers.
Technological advancements in the formulation of coatings,
the expertise necessary to choose the appropriate coating
solution for each infrastructure asset, the proper inspection
by certified coatings inspectors and the proper surface
preparation and application by certified coatings applicators,
has increased the professionalism of the industry and
elongated the expected performance life-cycles.
10

11. 11
ECONOMIC
REALITIES

12. It is an age-old problem… too great the number of
initiatives, too few the funding resources.
However, if we only focus on the short-term economics,
we may lose sight of the ”long-view” savings.
The Cost of Public Safety
12

13. Every additional dollar invested
in drinking water and wastewater
sector results in an increase in
revenue for all industries of $2.62.8
A Deeper Look at the Numbers
13

14. Funding Snapshot
14
Between 1956 and
2010, government
spending on water and
wastewater utilities
grew nearly every year,
yet since 2010 has
been in a steady
decline.
Total federal, state and local government spending on water
and wastewater utilities grew steadily over time
But declined 8% between 2010 and 2014
Reported in billions of 2014 dollars$120
$100
$80
$60
$40
$20
$0
1956 1966 1976 1986 1996 2006 2014
$118
$109
Source: Congressional Budget Office

15. State and local government spending on water and wastewater
utilities continued to grow while federal spending declined since
the 1980s
State and local governments spent 24 times as much as the federal
government in 2014
Reported in billions of 2014 dollars$120
$100
$80
$60
$40
$20
$0
1956 1966 1976 1986 1996 2006 2014
$114
$105
$17
$4.4Federal government
Funding Snapshot
15
The paradigm shift to
public spending is now
largely paid for by state
and local governments,
greatly surpassing
federal contributions.
Source: Congressional Budget Office

16. 16
QUALIFICATIONS

17. Stringent Industry Standard
enacted in 2004.
Standard shows proficiency in:
Environmental Safety and Health;
Process Control; Materials; Surface
Preparation; and Coating Application.
Certification Test: Is administered by a
3rd Party and tests knowledge, skill and
overall proficiency.
What is the “NACE 13/SSPC ACS-1 Standard?”
17

18. Inspector and Specification Writer Programs
The Protective Coatings Specialist Program (PCS) –
introduction to coatings and linings used to control
corrosion… defines and examines common coatings,
addressing when, how and why they should be used.
NACE Coating Inspector Program (CIP) – for over 30 years,
the “gold standard” for inspections in the protective
coatings industry.
18
The SSPC Protective Coatings Inspector Program (PCI) –
training in proper methods of inspection for surface
preparation and installation of industrial and marine
protective coatings and lining systems.

19. Independent Cost-Benefit Analysis
19
Location
Contractor
Certification
Contract Award
Final Contract Cost
Material
$/Sq Foot
NFESC Support
Total
Time
Qualified
Personnel
San Diego, CA
YES
$ 320 K
$ 320 K
$ 30 K
$ 17.50
$ 40 K
$ 390 K
2 months
Non-qualified
Personnel
Pensacola, FL
None
$ 320 K
$ 600 K
$ 30 K
$ 31.50
$ 240 K
$ 870 K
5 months
US Navy’s Naval Facilities
department (NAVFAC) did a cost-
benefit analysis regarding the use
of certified or non-certified
contractors on coatings projects.
The results showed that utilizing
certified contractors and trained
personnel has proven an
overwhelming “cost-benefit”
success.

20. The NACE 13/SSPC ACS-1
Standard was firmly in place
to execute the massive Capitol
Dome Restoration Project.
Case Study
20

21. American workforce, well versed
in the up-to-date techniques
and equipment to truly make
a difference in fighting corrosion.
The Coating Application Specialist
21

22. 22
TAKEAWAYS

23. Preservation Through Mitigation
We can expand
expected lifetimes of
these structures up to9
100 Years!
23

24. Responsible Economics
30%
Through proper
mitigation, costs
can be reduced
by as much as10
24

25. Harnessing the expertise
of those trained to handle
these types of projects brings
about the culmination of
The Coating Solution.
Certified Personnel
25

26. 26
Proper Assessment & Selection
+Qualified Applicators & Contractors
+ Certified Inspectors
The Coating Solution = Quality Job

27. The Coating Solution Forum presents:
The Importance of Corrosion Prevention —
Presented by:
REINFORCING OUR NATION’S
INFRASTRUCTURE.

28. THANK YOU
28

29. APPENDIX
29

30. 30
1 American Society of Civil Engineers (ASCE)
2 The Center for Neighborhood Technology (CNT)
3 Miller Water Infrastructure Report
4 United States Environmental Protection Agency
5 United States Environmental Protection Agency
6 WaterWorld; TBD
7 American Water Works Association
8 American Water Works Association
9 WaterWorld
10 NACE® International
Appendix