Fufu is a fermented wet-paste made from fresh cassava tubers. It is made by steeping whole or cut peeled cassava roots in water to ferment for two or three days and then dewater and dry it to get fufu, the fermentation time depending on ambient temperature. To produce high quality fufu flour, the used fufu flour processing machine includes complete set of machine for cleaning and fermentation section, fufu flour processing section and drying section.

1. Fufu flour processing machine
Fufu is a fermented wet-paste made from fresh cassava tubers. It is made by
steeping whole or cut peeled cassava roots in water to ferment for two or three days
and then dewater and dry it to get fufu, the fermentation time depending on
ambient temperature. To produce high quality fufu flour, the used fufu flour
processing machine includes complete set of machine for cleaning and fermentation
section, fufu flour processing section and drying section.
Cassava
The conveying and cleaning section:
When production begins cassava roots will be taken by a shovel loader out of raw
material storage platform into the hopper. DOING cassava feeding hopper is
designed with vibration device, which will ensure no blocking when feeding.
Then the fresh cassava is conveyed through hopper to a conveyor. In this fufu flour
processing machine, the cassava roots are dropped evenly onto the belt of an
inclined belt conveyor where stems and branches are picked out and woody tissues
of cassava roots are manually cut off. With this procedure, impurities and peeling
can be cleaned out directly, this is very important base of processing high quality
fufu flour.

2. In the cleaning section, stems and branches mixed in the harvested cassava roots
and impurities such as sand will be get rid of by fufu flour processing machine.
Then cassava enters in a cassava washer, where peels as well as dirt of cassava roots
will be removed. This fufu flour processing machine is designed to remove the
cassava outer peels to reduce the load of the next machine.
Cassava washer

3. Cassava fufu flour processing section
In this section, the cassava fufu flour processing machine including cassava cutter
machine, rasper, Plate and frame filter press, different screw conveyors, hammer
mill etc.
Cutting machine
After getting the peeled cassava, cassava cutter will cut the peeled cassava into small
particles and convey it to the the fermentation tank directly, after fermentation
around 6 hours, convey the small cassava tubers into the rasper machine directly.

4. To ensure the very good quality of fufu flour with better fineness, it is essential to
match the rasper. For this fufu flour processing machine can grate cassava into pulp
at high speed and the grated cassava is finer.
After getting the pure fufu flour pulp, using a screw pump to pump the milk into the
plate and frame filter press for dewatering. The moisture after dewatering will be
around 40%~45%. The dewatered cake shall be broke by hammer mill for better
drying.

5. Dewatering machine
Cassava fufu flour drying section
The wet fufu cake is dried in a flash dryer, whose heating source of flash dryer can be
steam or hot wind. Wet cassava fufu flour is heated and dried by hot wind and water
is steamed. After drying, the moisture is around 12%. And this fufu flour processing
machine uses negative pressure system, which can save more energy for clients.

6. Flash dryer
After drying cassava fufu flour, collected cassava fufu flour is transported to
vibration sifter, where the coarse particulate matter will be sieved out. The sieved
cassava fufu flour is transported to hopper for storing, cooling and packaging
according to client's requirements.
Above is the mainly used fufu flour processing machine. Henan Doing Company has
been devoted in cassava deep processing machine for decades of years, our
technology for fufu processing is advanced, your inquiry about fufu flour processing
machine is welcomed.
Tel/Whatsapp: +86-13526615783
Website: www.cassavaprocessing.com
Email: sales@doingmachinery.com